Precautions with regard to safety
Cautions when installing
Important Information
Avoid setting up in places which are subject to vibration or shocks.
The internal parts can be damaged, which may cause malfunctions or accidents.
Avoid setting up in places which are subject to sudden temperature changes, such as near an air conditioner or lighting equipment.
The life of the lamp may be shortened or the projector may be turned off. See “TEMP indicator” on page 42.
Do not set up the projector near
The projector may be subject to electromagnetic interference.
If installing the projector to the ceiling, ask a qualified technician to carry out all installation work.
You will need to purchase the separate installation kit. Furthermore, all installation work is should only be carried out by a qualified technician.
If using this projector at high elevations, 1 400 -
2 700 m (4 593 - 8 858 ft) sea level, set the ALTITUDE to HIGH. See “ALTITUDE” on page 36.
Failure to observe this may result in malfunctions or the life of the lamp or the other components may be shortened.
Do not use the projector at high elevation higher than 2 700 m (8 858 ft).
Cautions on use
In order to get the best picture quality
Draw curtains or blinds over any windows and turn off any lights near the screen to prevent outside light or light from indoor lamps from shining onto the screen.
Optical components
If you use the projector consecutively 6 hours every day, the optical components may need to be replaced in less than 1 year.
Liquid crystal panel
Do not project the same image for long periods of time, as this may remain as an afterimage on the liquid crystal panel. Display the white screen test pattern for more than an hour to remove it. See “TEST PATTERN” on page 37.
The liquid crystal panel of the projector is built with very high precision technology to provide fine picture details. Occasionally, a few stuck pixels may appear on the screen as fixed points of blue, green or red. It is recommended to switch off the projector once and try after 1 hour later again. Please note that this does not affect the performance of your LCD.
The projector has a high pressure mercury lamp and that is characterized as follows:
The brightness of the lamp depends on the duration of use.
The lamp may explode or shorten the lamp life by shocks or chipping damage.
The lamp may explode only occasionally after using the projector.
When the lamp exploded, it emits the internal smoke- like gas.
The lamp may explode if using the projector after the instructed lamp replacement timing.
The lamp life is depends on individual lamp characteristics, usage condition and the installation environment. Especially the consecutive use of the projector for more than 10 hours, or the frequent switching on or off may greatly affect on the lamp life.
Do not touch the surfaces of the lens or lens cover with your bare hands.
If the surface of the lens cover becomes dirty from fingerprints or anything else, this will be magnified and projected onto the screen.
Security
Take safety measures for use of the projector which should cover the following envisioned incidents.
The leakage of your personal registered information. Dishonest operation by an untrusted third party. Locking out or prevent anyone else from using the projector by an untrusted third party.
Security instruction
Change your password regularly.
Do not use too simple password to guess.
Any of Authorized Service Centers will never ask you for the password.
Do not share your password with the general public. Secure the network environment by the firewall.