Nortel Networks P0607274 0 manual UPSConsoleToggle Service, UPS Configuration screen

Page 24

24Chapter 2 Install and Initialize the Uninterruptable Power Supply

5Select the UPS Configuration tab from the UPS setup screen. The UPS Configuration screen appears (see Figure 3 on page 24).

Figure 3 UPS Configuration screen

6Select the UPS radio button to enable the serial port for use by the UPS.

7Select the power source type (110 ~ 120v or 220 ~ 240v).

Note: Once the UPS is selected and enabled on the Unified Manager “Serial Selection Page”, the UPS sends the message “UPS Communication Established” to the NT event log, when the UPS communication started. If the BCM loses or cannot establish a link to the UPS, an error log appears “Unable to Communicate with the UPS”.

8This procedure is complete.

UPSConsoleToggle Service

UPSConsoleToggle is an Auto-Start service that initiates at system boot time to enable the serial console for 15 minutes. Plug the console serial cable into the BCM and work on BCM console for a period of 15 minutes.

P0607274 02

Image 24

Contents Part No. P0607274 March 24 Safety North American Regulatory InformationRadio-frequency Interference Telecommunication RegistrationElectromagnetic Compatibility Telephone Company Registration Rights of the Telecommunications CompanyRepairs Canadian Regulations please read carefullyUS Regulations please read carefully Federal Communications Commission FCC NoticeImportant Safety Instructions Use Risk of shock Preface P0607274 Preface Display TipsSymbols used in this guide Acrobat Reader display setup selectionsHow to Get Help Text conventionsRelated publications Preface P0607274 Chapter Uninterruptable Power Supply UPS Overview UPS OverviewBCM and UPS power and control connections BCM Input Power SourceAlarm and event reporting UPS threshold valuesUPS Event messages Uninterruptable Power Supply UPS Overview UPS Event messages UPS default configuration settings Operational measurements and accountingShutdown Uninterruptable Power Supply UPS Overview P0607274 Install and Initialize the UPS Initialize the serial portUPSConsoleToggle Service UPS Configuration screenEnable UPSConsoleToggle Enable the console batch file Chapter Monitor the Uninterruptable Power Supply Monitor the UPSAccess the UPS Status monitor UPS Status Monitor screenAccess the UPS OM and log reports UPS OMs reportAccess the UPS status report UPS Log file reportTest the UPS UPS status reportMonitor the Uninterruptable Power Supply