Nortel Networks P0607274 0 manual Monitor the Uninterruptable Power Supply

Page 32

32Chapter 3 Monitor the Uninterruptable Power Supply

4Verify that a warning message and/or alert appears on the client screen.

5Wait until the UPS battery reaches a low level. A system shutdown should occur (on the BCM 200, 400, and 1000).

6After system shutdown, restore power to the UPS device.

7Check the system log in the Event Viewer to ensure that all actions are logged and that there are no errors.

8This procedure is complete.

P0607274 02

Image 32

Contents Part No. P0607274 March 24 Safety North American Regulatory InformationElectromagnetic Compatibility Radio-frequency InterferenceTelecommunication Registration Telephone Company Registration Rights of the Telecommunications CompanyRepairs Canadian Regulations please read carefullyUS Regulations please read carefully Federal Communications Commission FCC NoticeImportant Safety Instructions Use Risk of shock Preface P0607274 Preface Display TipsSymbols used in this guide Acrobat Reader display setup selectionsRelated publications How to Get HelpText conventions Preface P0607274 Chapter Uninterruptable Power Supply UPS Overview UPS OverviewBCM and UPS power and control connections BCM Input Power SourceAlarm and event reporting UPS threshold valuesUPS Event messages Uninterruptable Power Supply UPS Overview UPS Event messages UPS default configuration settings Operational measurements and accountingShutdown Uninterruptable Power Supply UPS Overview P0607274 Install and Initialize the UPS Initialize the serial portUPSConsoleToggle Service UPS Configuration screenEnable UPSConsoleToggle Enable the console batch file Chapter Monitor the Uninterruptable Power Supply Monitor the UPSAccess the UPS Status monitor UPS Status Monitor screenAccess the UPS OM and log reports UPS OMs reportAccess the UPS status report UPS Log file reportTest the UPS UPS status reportMonitor the Uninterruptable Power Supply