Dell DCSM specifications Removing a Floppy Drive

Page 28

1.Check the documentation for the drive to verify that it is configured for your computer.

2.Follow the procedures in "Before you Begin."

3.Remove the plastic guide bracket from the inside of the hard-drive bay by gently pulling the bracket up and out of the bay.

4.Snap the bracket to the hard drive.

5.Gently slide the new drive (second hard drive) into place until it clicks or you feel the drive securely installed.

1primary hard drive in upper bay

2secondary hard drive in lower bay

3rail tabs (2)

4hard drive bay

6.Connect a power cable to the drive.

7.Connect the data cable to the drive and to the system board.

Floppy Drive

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive."

Removing a Floppy Drive

1.Follow the procedures in "Before you Begin."

2.Remove the drive panel.

Image 28
Contents Abbreviations and Acronyms About Your Dell Dimension 5000 Computer Front View of ComputerBack View of Computer LightsBack to Contents Advanced Troubleshooting Dell DiagnosticsWhen to Use the Dell Diagnostics Starting the Dell Diagnostics From Your Hard DriveDell Diagnostics Main Menu Power Light Problem Description Suggested ResolutionSystem Lights Option FunctionDiagnostic Lights Light Pattern Problem Description Suggested ResolutionBeep Codes Code CauseBack to Contents Before You Begin Getting StartedRecommended Tools Turning Off Your ComputerBack to Contents Replacing the Computer Cover Removing the Computer Cover Memory Removing and Installing PartsDDR2 Memory Overview Addressing Memory With 4-GB Configurations Installing MemoryRemoving Memory CardsPCI Cards Installing a PCI Card Removing a PCI Card Installing a PCI Express Card PCI Express CardsPage Removing a PCI Express Card Drive Panels Removing the Drive PanelReplacing the Drive-Panel Insert Removing the Drive-Panel InsertReplacing the Drive Panel Drives Connecting Drive Cables Drive Interface ConnectorsPower Cable Connector Connecting and Disconnecting Drive CablesHard Drive Removing a Hard DriveInstalling a Hard Drive Adding a Second Hard DriveFloppy Drive Removing a Floppy DriveInstalling a Floppy Drive Replace the computer cover Media Card Reader Removing a Media Card ReaderInstalling a Media Card Reader Remove the computer coverCD/DVD Drive Removing a CD/DVD DriveInstalling a CD/DVD Drive Replace the computer cover Processor Removing the ProcessorInstalling the Processor System Board Jumper Setting Description Jumper SettingsRemoving the System Board Removing the Power Supply Power SupplyReplacing the System Board Replacing the Power Supply Battery Replacing the BatterySpecifications Drives ConnectorsControls and Lights Physical PowerEnvironmental System Setup Entering System SetupSystem Setup Screens OverviewSystem Setup Options PXE. When the On w/ PXE setting is activeUSB, Internal, or Read Only COM3System Password option Are every day or every Monday through FridayBoot Sequence Option SettingsChanging Boot Sequence for the Current Boot Changing Boot Sequence for Future BootsClearing Forgotten Passwords Clearing Cmos SettingsBack to Contents Technical Overview Inside View of Your Computer System Board ComponentsPower Supply DC Connector Pin Assignments DC Power Connector P1Pin Number Signal Name 18-AWG Wire COMAbbreviations and Acronyms
Related manuals
Manual 217 pages 3.31 Kb Manual 158 pages 23.31 Kb Manual 72 pages 7.23 Kb