Dell DCSM specifications Installing a Floppy Drive

Page 29

1power cable

2data cable

3. Disconnect the power and data cables from the back of the floppy drive.

NOTE: If you are installing a PCI Express x16 card, this card may cover the floppy-drive connectors. Remove this card before connecting the floppy-drive cables.

4. Remove the floppy drive by sliding and holding the drive latch release downward. Then, slide the drive out of the computer.

1sliding plate lever

2sliding plate

3floppy drive

Installing a Floppy Drive

NOTE: In the event the replacement or new floppy drive does not have the shoulder screws, use the screws located within the drive panel insert.

Image 29

Contents Abbreviations and Acronyms Front View of Computer About Your Dell Dimension 5000 ComputerLights Back View of ComputerBack to Contents Dell Diagnostics Advanced TroubleshootingWhen to Use the Dell Diagnostics Starting the Dell Diagnostics From Your Hard DrivePower Light Problem Description Suggested Resolution Dell Diagnostics Main MenuSystem Lights Option FunctionLight Pattern Problem Description Suggested Resolution Diagnostic LightsCode Cause Beep CodesBack to Contents Getting Started Before You BeginRecommended Tools Turning Off Your ComputerBack to Contents Replacing the Computer Cover Removing the Computer Cover DDR2 Memory Overview Removing and Installing PartsMemory Installing Memory Addressing Memory With 4-GB ConfigurationsPCI Cards CardsRemoving Memory Installing a PCI Card Removing a PCI Card PCI Express Cards Installing a PCI Express CardPage Removing a PCI Express Card Removing the Drive Panel Drive PanelsReplacing the Drive Panel Removing the Drive-Panel InsertReplacing the Drive-Panel Insert Drives Drive Interface Connectors Connecting Drive CablesPower Cable Connector Connecting and Disconnecting Drive CablesRemoving a Hard Drive Hard DriveAdding a Second Hard Drive Installing a Hard DriveRemoving a Floppy Drive Floppy DriveInstalling a Floppy Drive Replace the computer cover Removing a Media Card Reader Media Card ReaderRemove the computer cover Installing a Media Card ReaderRemoving a CD/DVD Drive CD/DVD DriveInstalling a CD/DVD Drive Replace the computer cover Removing the Processor ProcessorInstalling the Processor System Board Removing the System Board Jumper SettingsJumper Setting Description Replacing the System Board Power SupplyRemoving the Power Supply Replacing the Power Supply Replacing the Battery BatterySpecifications Controls and Lights ConnectorsDrives Environmental PowerPhysical Entering System Setup System SetupSystem Setup Screens OverviewPXE. When the On w/ PXE setting is active System Setup OptionsUSB, Internal, or Read Only COM3Are every day or every Monday through Friday System Password optionOption Settings Boot SequenceChanging Boot Sequence for the Current Boot Changing Boot Sequence for Future BootsClearing Cmos Settings Clearing Forgotten PasswordsBack to Contents Inside View of Your Computer System Board Components Technical OverviewDC Power Connector P1 Power Supply DC Connector Pin AssignmentsCOM Pin Number Signal Name 18-AWG WireAbbreviations and Acronyms

Related manuals

Manual 217 pages 3.31 Kb

Manual 158 pages 23.31 Kb

Manual 72 pages 7.23 Kb