Media Card Reader
Removing a Media Card Reader
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
1.Follow the procedures in "Before you Begin."
2.Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3.Replace the computer cover.
4.Remove the drive panel.
1cables
2Media Card Reader (not present on all computers)
5.Disconnect the cable on the back of the Media Card Reader to the front panel USB connector on the system board and route the cable through the clip on the shroud.