Cognitive Solutions EZLP-UG00000 user manual Printer Installation, Setting up the EZ-LP Printer

Page 7

Chapter 2: Printer Installation

Setting up the EZ-LP Printer

Connecting the Interface and Power Cables

IMPORTANT! PRIOR TO CONNECTING ANY INTERFACE CABLE AND POWER CABLE TO PRINTER, MAKE SURE PRINTER IS OFF.

POWER OFF

1.Make sure power switch is OFF

2.Connect power cable to AC adapter

3. Connect the AC adapter to the power

4. Plug the power cable into an AC

connector on the printer

outlet

5.Connect the interface cable to the rear of the printer. For Serial or Parallel cables, securely fasten the interface connector screws or clips.

NOTE: EZ-LP IS

CONFIgured to use standard straight- through serial cable when using the com/ser port to connect to a dte device such as a computer.

USB

Power OFF

USB-B

(Device)

ETHERNET

Power OFF

Ethernet

I O I O

COM/SER

Power OFF

 

Serial

 

(DB9)

 

PARALLEL

 

Parallel

 

(Centronics)

Power OFF

Ferrite Bead

(Install on Parallel Cable as Shown)

7

Image 7
Contents USER’S Manual Copyright 2009, CognitiveTPG Table of Contents Operating Environment Package ContentsIntroduction WelcomeFront/Rear View Printer Feature OverviewComponent Function Inside View Setting up the EZ-LP Printer Printer InstallationConnecting the Interface and Power Cables Cognitivetpg Approved Loading MediaClick Power OFF printer to end hexadecimal dump mode Self-TestingInstalling the EZ-LP Select Keep existing driver recommended and click Next Page Cognitivetpg Printer Installing Printer via USB Windows Driver InstallationPage Connection Settings CognitiveTPG Printer Administrator UtilitySelect the System Printer Connection radio dial Select the Use Network Connection radio dial Printer SettingsValues Label Positioning Auto Recalibration Click the Delete Selected Objects button Profile Management Script Editor Firmware UpgradePage Making Configurations Changes Using DOS Commands Advanced EZ-LP FeaturesUSB a Port Cleaning Supplies Cleaning and MaintenanceCleaning the Printer Cleaning the Thermal Printhead and PlatenSymptom Possible Cause Recommended Solution Troubleshooting & Default SettingsParameter Default Setting