Replacement Procedures
Installing the display assembly
The following describes the procedure for installing the display assembly (See Figure
1.Inserting the pole of hinge to the hole of hinge assembly, set the display assembly on the base assembly.
2.Secure the hinges with the following screws , Secure the display mask with the following screws and stick the mask seal on them.
• M2.5⋅6.0B FLAT BIND screw | x4 |
(Locktight) |
|
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
3.Connect the LCD harness to the connector on the system board.
4.Arrange the wireless antenna cables along the guide (front) and secure them with guide.
5.Pass the cables to the back of computer through the slot.
6.Install the keyboard and k/b cover of the system.
7.Arrange the wireless LAN antenna and Bluetooth cables along the guide and contact with the connector.
8.Secure the display assembly from the back of computer with the following screws.
• M2.5⋅6.0B FLAT BIND screw | x4 |
(Locktight) |
|
Satellite P100 Maintenance Manual |
