Replacement Procedures
4.17 System board
CAUTION: 1. When handling the system board, always hold by the edges. Do not touch the printed circuit face.
2.If replacing with a new system board, execute the subtest01 Initial configuration in section 3.3 “Setting of the hardware configuration”. Also update with the latest BIOS as described in Appendix G “BIOS Rewrite Procedures” and with the latest EC/KBC as described in Appendix H “EC/KBC Rewrite Procedures”.
Removing the system board
The following describes the procedure for removing the system board (See Figure
1.Disconnect the speaker cable from the connector CN10 on the system board.
2.Remove the following screws securing the system board and remove the system board.
• M2.5⋅4.0 BIND screw | x3 |
M2.5x4.0 BIND SCREW
CN10
Speaker cable
Audio board cable
Figure 4-26 Removing the system board
Satellite P100 Maintenance Manual |
