The Speaker Company TTP-245 Plus user manual

Page 52

 

Corporate Headquarters

Li Ze Plant

 

9F., No.95, Minquan Rd., Xindian Dist.,

No.35, Sec. 2, Ligong 1st Rd., Wujie Township,

 

New Taipei City 23141, Taiwan (R.O.C.)

Yilan County 26841, Taiwan (R.O.C.)

 

TEL: +886-2-2218-6789

TEL: +886-3-990-6677

 

FAX: +886-2-2218-5678

FAX: +886-3-990-5577

 

Web site: www.tscprinters.com

 

TSC Auto ID Technology Co., Ltd.

E-mail: printer_sales@tscprinters.com

 

 

tech_support@tscprinters.com

 

 

 

 

 

 

 

47

Page 51 Page 52
Image 52
Page 51 Page 52
Contents
TTP-245 Plus / TTP-343 Plus TTP-247 / TTP-345 Contents LED Copyright Declaration Compliances UL, CUL급기기 Equipment Checklist IntroductionGetting Started Unpacking and InspectionDealer option Printer Parts Top front viewSetup Setting Up the PrinterLoading the Ribbon Thread the ribbon leading tape downward pass the print headRibbon installation Label roll installation Loading Label StockLabel installation External Label Roll Mount Installation Option Attach the external roll mount to the printerThen push down the top cover gently Peel-off Module Installation Option Remove the front panelConnect peelTenonsensor cable to main board Peel-off panel installation Loading the Paper in Peel-off Mode Open the top coverComplete label installation for peel-off mode Cutter Module Installation Option Cutter module installation Cutter Niche Loading Label in Cutter Mode Label installation in cutter modeInstructions to Top Cover Operation Top cover is fully open and ready to close Diagnostic Tool Start the Diagnostic ToolFunction Description Setting Ethernet by Diagnostic Utility Option Using USB interface to setup Ethernet interfaceUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Install Memory Card SD card spec SD card capacity Approved SD card manufacturerV1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Power on Utilities Ribbon and Gap/Black Mark Sensor CalibrationGap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension Dump mode Dump mode printoutPrinter Initialization Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor Skip AUTO.BASPrinter will be interrupted to run the AUTO.BAS program Maintenance CleaningInterior Troubleshooting LED StatusProblem Possible Cause Recovery Procedure Print QualityPage LED LED and Button OperationButton Operation Gap/Black Mark Set Gap Sensor as Date Content Editor Revise History