The Speaker Company TTP-245 Plus user manual Revise History, Date Content Editor

Page 51

Revise History

Date

Content

Editor

2008/2/29

*Add section 3.8: Diagnostic Tool

Camille

*Add the IP Address default setting

 

 

 

 

 

 

2008/3/6

*Revise section 2.2

Camille

*Add section 3.9: Install memory card

 

 

 

 

 

 

2008/3/7

*Revise the printer default setting

Camille

*Revise section 3.6, 4.2 and 5.1

 

 

 

 

 

 

2008/3/10

Revise the section 6

Camille

 

 

 

2009/3/11

Revise section 3.9 (Recommended SD card specification)

Camille

 

 

 

2009/6/16

*Add TTP-247/345 model name

Camille

 

*Revise section 4.2

 

 

*Add caution to compliances section

 

 

 

 

2009/10/14

*Revise section 3.8

Camille

 

*Add section 3.9

 

 

 

 

2010/11/23

* Revise compliances section

Camille

 

* Revise section 2.3 and 3.1

 

 

 

 

2011/1/25

Modify TSC address

Camille

 

 

 

2013/4/2

Modify section 2.2(cutter spec) and 4.2(V7.0 F/W self test)

Camille

 

Add TSC YouTube web address

 

 

 

 

46

Image 51 Contents
TTP-245 Plus / TTP-343 Plus TTP-247 / TTP-345 Contents LED UL, CUL Copyright Declaration Compliances급기기 Unpacking and Inspection Equipment ChecklistIntroduction Getting StartedDealer option Top front view Printer PartsSetting Up the Printer SetupThread the ribbon leading tape downward pass the print head Loading the RibbonRibbon installation Loading Label Stock Label roll installationLabel installation Attach the external roll mount to the printer External Label Roll Mount Installation OptionThen push down the top cover gently Remove the front panel Peel-off Module Installation OptionConnect peelTenonsensor cable to main board Peel-off panel installation Open the top cover Loading the Paper in Peel-off ModeComplete label installation for peel-off mode Cutter Module Installation Option Cutter module installation Cutter Niche Label installation in cutter mode Loading Label in Cutter ModeInstructions to Top Cover Operation Top cover is fully open and ready to close Start the Diagnostic Tool Diagnostic ToolFunction Description Using USB interface to setup Ethernet interface Setting Ethernet by Diagnostic Utility OptionUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page SD card spec SD card capacity Approved SD card manufacturer Install Memory CardV1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Ribbon and Gap/Black Mark Sensor Calibration Power on UtilitiesGap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension Dump mode printout Dump modePrinter Initialization Skip AUTO.BAS Set Gap Sensor as Media Sensor and Calibrate the Gap SensorPrinter will be interrupted to run the AUTO.BAS program Cleaning MaintenanceInterior LED Status TroubleshootingPrint Quality Problem Possible Cause Recovery ProcedurePage LED and Button Operation LEDButton Operation Gap/Black Mark Set Gap Sensor as Revise History Date Content Editor