The Speaker Company TTP-245 Plus user manual Install Memory Card

Page 33

3.10Install Memory Card

1.Turn the printer upside down.

2.Remove the screw that fixes the memory card cover.

Screw

Memory Card Cover

3.Plug in the memory card on main board.

TTP-245/343 Model (Option)	TTP-245 Plus/343 Plus/247/345
	Model (SD Card)

4.Close the memory card cover.

*Recommended SD card specification.

SD card spec	SD card capacity	Approved SD card manufacturer

V1.0, V1.1	128 MB	SanDisk, Transcend

V1.0, V1.1	256 MB	SanDisk, Transcend, Panasonic

V1.0, V1.1	512 MB	SanDisk, Transcend, Panasonic

V1.0, V1.1	1 GB	SanDisk, Transcend, Panasonic

V2.0 SDHC CLASS 4	4 GB

V2.0 SDHC CLASS 6	4 GB	SanDisk, Transcend, Panasonic

V1.0, V1.1	microSD 128 MB	Transcend, Panasonic

V1.0, V1.1	microSD 256 MB	Transcend, Panasonic

		28

Image 33

Contents

TTP-245 Plus / TTP-343 Plus TTP-247 / TTP-345 Contents LED UL, CUL Copyright Declaration Compliances급기기 Introduction Equipment ChecklistGetting Started Unpacking and InspectionDealer option Top front view Printer PartsSetting Up the Printer SetupThread the ribbon leading tape downward pass the print head Loading the RibbonRibbon installation Loading Label Stock Label roll installationLabel installation Attach the external roll mount to the printer External Label Roll Mount Installation OptionThen push down the top cover gently Remove the front panel Peel-off Module Installation OptionConnect peelTenonsensor cable to main board Peel-off panel installation Open the top cover Loading the Paper in Peel-off ModeComplete label installation for peel-off mode Cutter Module Installation Option Cutter module installation Cutter Niche Label installation in cutter mode Loading Label in Cutter ModeInstructions to Top Cover Operation Top cover is fully open and ready to close Start the Diagnostic Tool Diagnostic ToolFunction Description Using USB interface to setup Ethernet interface Setting Ethernet by Diagnostic Utility OptionUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page SD card spec SD card capacity Approved SD card manufacturer Install Memory CardV1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Ribbon and Gap/Black Mark Sensor Calibration Power on UtilitiesGap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension Dump mode printout Dump modePrinter Initialization Skip AUTO.BAS Set Gap Sensor as Media Sensor and Calibrate the Gap SensorPrinter will be interrupted to run the AUTO.BAS program Cleaning MaintenanceInterior LED Status TroubleshootingPrint Quality Problem Possible Cause Recovery ProcedurePage LED and Button Operation LEDButton Operation Gap/Black Mark Set Gap Sensor as Revise History Date Content Editor