The Speaker Company TTP-245 Plus Loading the Paper in Peel-off Mode, Open the top cover

Page 19

3.5.1 Loading the Paper in Peel-off Mode

1.Insert a 1” label spindle into a paper roll.

2.Open the printer top cover by pulling the top cover open levers. The top cover support will hold the printer top cover.

Peel-off panel

Backing paper

Opening

Top Cover Open Lever

Fig. 18 Open the top cover

3.Install the paper roll on the paper roll mount.

4.Open the peel-off panel by pulling it out.

Peel-off

panel

Fig. 19 Open the peel-off panel

5.Feed the paper, printing side facing up, through the paper guide and pass over the platen.

14

Image 19

Contents

TTP-245 Plus / TTP-343 Plus TTP-247 / TTP-345 Contents LED UL, CUL Copyright Declaration Compliances급기기 Unpacking and Inspection Equipment ChecklistIntroduction Getting StartedDealer option Top front view Printer PartsSetting Up the Printer SetupThread the ribbon leading tape downward pass the print head Loading the RibbonRibbon installation Loading Label Stock Label roll installationLabel installation Attach the external roll mount to the printer External Label Roll Mount Installation OptionThen push down the top cover gently Remove the front panel Peel-off Module Installation OptionConnect peelTenonsensor cable to main board Peel-off panel installation Open the top cover Loading the Paper in Peel-off ModeComplete label installation for peel-off mode Cutter Module Installation Option Cutter module installation Cutter Niche Label installation in cutter mode Loading Label in Cutter ModeInstructions to Top Cover Operation Top cover is fully open and ready to close Start the Diagnostic Tool Diagnostic ToolFunction Description Using USB interface to setup Ethernet interface Setting Ethernet by Diagnostic Utility OptionUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page SD card spec SD card capacity Approved SD card manufacturer Install Memory CardV1.0 MicroSD 512 MB Panasonic Transcend, Panasonic Ribbon and Gap/Black Mark Sensor Calibration Power on UtilitiesGap/Black Mark Calibration, Self-test and Dump Mode Self-test Gap/black mark sensor intension Dump mode printout Dump modePrinter Initialization Skip AUTO.BAS Set Gap Sensor as Media Sensor and Calibrate the Gap SensorPrinter will be interrupted to run the AUTO.BAS program Cleaning MaintenanceInterior LED Status TroubleshootingPrint Quality Problem Possible Cause Recovery ProcedurePage LED LED and Button OperationButton Operation Gap/Black Mark Set Gap Sensor as Revise History Date Content Editor