The Speaker Company
TTP-245 Plus
user manual
Then push down the top cover gently
Troubleshooting
Install
Maintenance
Diagnostic Tool
Setup
Checklist
Power on Utilities
Loading Label in Cutter Mode
Page 15
then push down the top
cover gently.
Rear Paper Guide
Top Cover Support
Paper Guide
Platen
Fig. 11 External roll mount label installation (II)
10
Page 14
Page 16
Image 15
Page 14
Page 16
Contents
TTP-245 Plus / TTP-343 Plus TTP-247 / TTP-345
Contents
LED
UL, CUL
Copyright Declaration Compliances
급기기
Unpacking and Inspection
Equipment Checklist
Introduction
Getting Started
Dealer option
Top front view
Printer Parts
Setting Up the Printer
Setup
Thread the ribbon leading tape downward pass the print head
Loading the Ribbon
Ribbon installation
Loading Label Stock
Label roll installation
Label installation
Attach the external roll mount to the printer
External Label Roll Mount Installation Option
Then push down the top cover gently
Remove the front panel
Peel-off Module Installation Option
Connect peelTenonsensor cable to main board
Peel-off panel installation
Open the top cover
Loading the Paper in Peel-off Mode
Complete label installation for peel-off mode
Cutter Module Installation Option
Cutter module installation
Cutter Niche
Label installation in cutter mode
Loading Label in Cutter Mode
Instructions to Top Cover Operation
Top cover is fully open and ready to close
Start the Diagnostic Tool
Diagnostic Tool
Function Description
Using USB interface to setup Ethernet interface
Setting Ethernet by Diagnostic Utility Option
Using RS-232 interface to setup Ethernet interface
Using Ethernet interface to setup Ethernet interface
Page
SD card spec SD card capacity Approved SD card manufacturer
Install Memory Card
V1.0 MicroSD 512 MB Panasonic Transcend, Panasonic
Ribbon and Gap/Black Mark Sensor Calibration
Power on Utilities
Gap/Black Mark Calibration, Self-test and Dump Mode
Self-test
Gap/black mark sensor intension
Dump mode printout
Dump mode
Printer Initialization
Skip AUTO.BAS
Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
Printer will be interrupted to run the AUTO.BAS program
Cleaning
Maintenance
Interior
LED Status
Troubleshooting
Print Quality
Problem Possible Cause Recovery Procedure
Page
LED and Button Operation
LED
Button Operation
Gap/Black Mark
Set Gap Sensor as
Revise History
Date Content Editor