4.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults. The only one exception is ribbon sensitivity, which will note be restored to default.
Printer initialization is activated by the following procedures.
1.Turn off the power switch.
2.Hold on the button then turn on the power switch.
3.Release the button when LED turns green after 5 amber blinks. (Any green will do during the 5 blinks).
The LED color will be changed as following:
Amber red (5 blinks) amber (5 blinks) green (5 blinks) green/amber (5 blinks) red/amber (5 blinks) solid green
Printer configuration will be restore to defaults as below after initialization.
Parameter | Default setting |
|
|
Speed | 203DPI :127 mm/sec (5 ips) |
| 300DPI: 76 mm/sec (3 ips) |
|
|
Density | 8 |
|
|
Label Width | 4” (101.6 mm) |
|
|
Label Height | 4” (101.6 mm) |
|
|
Sensor Type | Gap sensor |
|
|
Gap Setting | 0.12” (3.0 mm) |
|
|
Print Direction | 0 |
|
|
Reference Point | 0,0 (upper left corner) |
|
|
Offset | 0 |
|
|
Tear Mode | On |
|
|
Peel off Mode | Off |
|
|
Cutter Mode | Off |
|
|
Serial Port Settings | 9600 bps, none parity, 8 data bits, 1 stop bit |
|
|
Code Page | 850 |
|
|
Country Code | 001 |
|
|
Clear Flash Memory | No |
|
|
IP Address | DHCP |
|
|
Note:
Always do gap/black mark sensor calibration after printer initialization.
35