3.3 Loading Label Stock
1.Insert a 1” label spindle into a paper roll ( * If your paper core is 1 inch, remove the 1.5” core adapter from the fixed tab. If label width is 4 inch wide, two fixing tabs are not required. ).
1.5” Core
Adapter*
Paper Roll
Fixed Tab
Printing Side
Face Up
1” Label Spindle
Fig. 6 Label roll installation (I)
2.Open the printer’s top cover by releasing the green top cover open levers located on each side of the printer and lifting the top cover. A top cover support at the rear of the printer will hold the printer top cover open.
Lower Cover
Fig. 7 Pull the lever to open the cover
3.Place a roll of paper onto the center of the paper roll mount.
4.Feed the paper, printing side face up, through the Teflon bar and the paper guide and pass over the platen.
5.Adjust the green
6.To close the printer top cover, lift the cover to the ultimate open angle then use
7