Nortel Networks 2700 manual Copyright 2007 Nortel Networks. All rights reserved, NN46110-311

Page 2

2

Copyright © 2007 Nortel Networks. All rights reserved.

The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations in this document are believed to be accurate and reliable, but are presented without express or implied warranty. Users must take full responsibility for their applications of any products specified in this document. The information in this document is proprietary to Nortel Networks Inc.

Trademarks

Nortel, the Nortel logo, the Globemark, and Contivity are trademarks of Nortel Networks.

Adobe and Acrobat Reader are trademarks of Adobe Systems Incorporated.

Hi/fn and LZS are trademarks of Hi/fn, Inc.

HyperTerminal is a trademark of Hilgraeve, Inc.

Intel is a trademark of Intel Corporation.

Microsoft, Windows, and Windows NT are trademarks of Microsoft Corporation.

Netscape and Netscape Navigator are trademarks of Netscape Communications Corporation.

All other trademarks are the property of their respective owners.

Statement of conditions

In the interest of improving internal design, operational function, and/or reliability, Nortel Networks Inc. reserves the right to make changes to the products described in this document without notice.

Nortel Networks Inc. does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.

USA requirements only

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance with the instruction manual, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures may be necessary to correct the interference at their own expense.

European requirements only

EN 55 022 statement

This is to certify that the Nortel Networks VPN Router 2700 is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022 Class A (CISPR 22).

NN46110-311 02.01

Image 2
Contents Nortel VPN Router Installation Copyright 2007 Nortel Networks. All rights reserved NN46110-311Nortel VPN Router Installation VPN Router EC Declaration of ConformityCanada requirements only General NN46110-311 Contents Chapter Cabling the VPN Router and turning the power on ContentsAppendix a Contents NN46110-311 Figures Figures Tables Tables 1000BASE-T 1000 GT Ethernet card FeaturesNew in this release New in this release NN46110-311 Getting help from the Nortel Web site How to get helpFinding the latest updates on the Nortel Web site Getting help over the phone from a Nortel Solutions Center How to get helpGetting help through a Nortel distributor or reseller How to get help NN46110-311 Preface Before you beginPreface Text conventionsAcronyms Related publications Nortel VPN Router Security Firewalls, Filters, NAT, and QoSPrinted technical manuals Topic Chapter Installing the Nortel VPN Router 2700 chassisDescription of the Nortel VPN Router Preparing to install the Nortel VPN Router Installing the Nortel VPN Router 2700 chassisShipment contents Additional equipment Site requirementsInstalling the chassis Installing the chassis on a flat surfaceInstalling the chassis in an equipment rack Rack-mount recommendationsAttaching the cage nuts to the rack Mounting the chassis in the equipment rack Replacing the front bezel Installing the Nortel VPN Router 2700 chassis NN46110-311 Chapter Cabling the VPN Router and turning the power on TopicInterfaces and cables for the VPN Router Connecting communications cablesCabling the VPN Router and turning the power on Rear view of the VPN Router Requirement Description Connecting the power cordPower cord requirements Verifying a successful installation Understanding the LEDs Front panel LED indicatorsIndicator Description Front panel LEDsLED indicators on the system 10/100BASE-TX Ethernet port LEDs on the system 10/100BASE-TX Ethernet port1000BASE-T 1000 GT Ethernet interface card LEDs LED indicators on the 10/100BASE-TX Ethernet interface card10/100BASE-TX Ethernet interface card LEDs 1000BASE-T 1000 MT Ethernet interface card LEDs LEDs on the 1000BASE-T 1000 MT Ethernet interface cardLED indicator on the 1000BASE-SX Ethernet interface card 1000BASE-SX Ethernet interface card LEDLED indicators on the 56/64K CSU/DSU WAN interface card 56/64K CSU/DSU WAN interface card LEDsTx/Rx LED Description LED indicators on the Adsl WAN interface cardAdsl WAN interface card LEDs LED indicators on the T1/E1 CSU/DSU WAN interface card T1/E1 CSU/DSU WAN interface card LEDsLED indicators on the quad T1/E1 CSU/DSU WAN interface card Quad T1/E1 CSU/DSU WAN interface card LEDsLED indicators on the single V.35/X.21 WAN interface card Single V.35/X.21 WAN interface card LEDsSSL VPN Module 1000 LEDs LED indicators on the SSL VPN ModuleLEDs Indicator Description Chapter Configuring the management IP interface Configuring the management IP interface Required informationConfiguring the management IP address Enter Old Subnet Mask = 0.0.0.0 New Subnet Mask = Type M, and press Enter Management IP Address prompt appears Testing the configuration Troubleshooting Chapter Installing option cards and DIMMs Installing option cards and DIMMs Shutting down the system to add or replace hardwareRemoving the front bezel and top cover Slide the top cover forward approximately 1/4 inch Location of option card slots and DIMMs on the system board Attaching the antistatic wrist strap Maximum Option card Number Restrictions Installing and replacing option cardsSupported option cards for the 2600 Installing other option cards with the SSL VPN Module Option card Restrictions with SSL VPN Module 1000 installed1000BASE-T or 1000BASE-SX interface Installing and removing an option card Press here Installing and replacing DIMMs Installing option cards and DIMMs Installing and removing a Dimm Installing option cards and DIMMs Installing option cards and DIMMs NN46110-311 Physical, electrical, and environmental specifications Appendix a Technical specificationsChassis specifications Specification DescriptionSystem ports 10/100BASE-TX Ethernet LAN port10/100BASE-TX Ethernet port pinouts Appendix a Technical specificationsSerial port Pin DescriptionSerial port DB9 connector DB25 connector Modem cable specificationsMultiple DB9 and DB25 connector pinouts Modem cable pinouts Nortel termination Modem termination Signal Pin # to Pin #Hardware option cards VPN Router Security Accelerator cards VPN Router Security Accelerator cardSSL VPN Module SSL VPN Module10/100BASE-TX Ethernet interface card 10/100BASE-TX Ethernet interface card1000BASE-T 1000 GT Ethernet interface card 1000BASE-T 1000 GT Ethernet interface card 1000BASE-T 1000 GT Ethernet pinouts1000BASE-T 1000 MT Ethernet interface card 1000BASE-T 1000 MTEthernet port pinoutsNN46110-311 1000BASE-SX Ethernet interface card 1000BASE-SX Ethernet interface card56/64K CSU/DSU WAN interface card 56/64K CSU/DSU WAN interface cardNortel termination Remote termination Signal Pin # to Pin # 56/64K CSU/DSU cable pinouts for straight-through connectionPin Function Adsl WAN interface cardAdsl cable pinouts Isdn BRI interface card Isdn BRI S/T cable pinoutsT1/E1 CSU/DSU WAN interface card Isdn BRI U cable pinoutsT1/E1 CSU/DSU WAN interface card full-height card T1/E1 CSU/DSU cable pinouts for crossover connectionT1/E1 CSU/DSU cable pinouts for straight-through connection Quad T1/E1 CSU/DSU WAN interface card Quad T1/E1 CSU/DSU WAN interface card90 modem cable pinouts Modem interface cardSingle V.35/X.21 WAN interface card 35 cable pinouts Appendix a Technical specifications 35 cable pinouts 21 cable pinoutsAppendix a Technical specifications 21 cable pinouts T3 cable pinouts Pin Scsi male Signal nameHssi WAN interface card GND RCA CAA RDA LCA STA TAA TTA LAA TDA LBA Testa Appendix a Technical specifications NN46110-311 Index NumericsIndex Index Index Index Index
Related manuals
Manual 12 pages 5.25 Kb