Nortel Networks 2700 manual General

Page 5

5

provide support of any kind for the Software. Some jurisdictions do not allow exclusion of implied warranties, and, in such event, the above exclusions may not apply.

3.Limitation of Remedies. IN NO EVENT SHALL NORTEL NETWORKS OR ITS AGENTS OR SUPPLIERS BE LIABLE FOR ANY OF THE FOLLOWING: a) DAMAGES BASED ON ANY THIRD PARTY CLAIM; b) LOSS OF, OR DAMAGE TO, CUSTOMER’S RECORDS, FILES OR DATA; OR c) DIRECT, INDIRECT, SPECIAL, INCIDENTAL, PUNITIVE, OR CONSEQUENTIAL DAMAGES (INCLUDING LOST PROFITS OR SAVINGS), WHETHER IN CONTRACT, TORT OR OTHERWISE (INCLUDING NEGLIGENCE) ARISING OUT OF YOUR USE OF THE SOFTWARE, EVEN IF NORTEL NETWORKS, ITS AGENTS OR SUPPLIERS HAVE BEEN ADVISED OF THEIR POSSIBILITY. The forgoing limitations of remedies also apply to any developer and/or supplier of the Software. Such developer and/or supplier is an intended beneficiary of this Section. Some jurisdictions do not allow these limitations or exclusions and, in such event, they may not apply.

4.General

a.If Customer is the United States Government, the following paragraph shall apply: All Nortel Networks Software available under this License Agreement is commercial computer software and commercial computer software documentation and, in the event Software is licensed for or on behalf of the United States Government, the respective rights to the software and software documentation are governed by Nortel Networks standard commercial license in accordance with U.S. Federal Regulations at 48 C.F.R. Sections 12.212 (for non-DoD entities) and 48 C.F.R. 227.7202 (for DoD entities).

b.Customer may terminate the license at any time. Nortel Networks may terminate the license if Customer fails to comply with the terms and conditions of this license. In either event, upon termination, Customer must either return the Software to Nortel Networks or certify its destruction.

c.Customer is responsible for payment of any taxes, including personal property taxes, resulting from Customer’s use of the Software. Customer agrees to comply with all applicable laws including all applicable export and import laws and regulations.

d.Neither party may bring an action, regardless of form, more than two years after the cause of the action arose.

e.The terms and conditions of this License Agreement form the complete and exclusive agreement between Customer and Nortel Networks.

f.This License Agreement is governed by the laws of the country in which Customer acquires the Software. If the Software is acquired in the United States, then this License Agreement is governed by the laws of the state of New York.

Nortel VPN Router Installation — VPN Router 2700

Image 5
Contents Nortel VPN Router Installation NN46110-311 Copyright 2007 Nortel Networks. All rights reservedEC Declaration of Conformity Nortel VPN Router Installation VPN RouterCanada requirements only General NN46110-311 Contents Contents Chapter Cabling the VPN Router and turning the power onAppendix a Contents NN46110-311 Figures Figures Tables Tables 1000BASE-T 1000 GT Ethernet card FeaturesNew in this release New in this release NN46110-311 Getting help from the Nortel Web site How to get helpFinding the latest updates on the Nortel Web site How to get help Getting help over the phone from a Nortel Solutions CenterGetting help through a Nortel distributor or reseller How to get help NN46110-311 Before you begin PrefacePreface Text conventionsAcronyms Nortel VPN Router Security Firewalls, Filters, NAT, and QoS Related publicationsPrinted technical manuals Topic Chapter Installing the Nortel VPN Router 2700 chassisDescription of the Nortel VPN Router Installing the Nortel VPN Router 2700 chassis Preparing to install the Nortel VPN RouterShipment contents Site requirements Additional equipmentInstalling the chassis on a flat surface Installing the chassisRack-mount recommendations Installing the chassis in an equipment rackAttaching the cage nuts to the rack Mounting the chassis in the equipment rack Replacing the front bezel Installing the Nortel VPN Router 2700 chassis NN46110-311 Topic Chapter Cabling the VPN Router and turning the power onInterfaces and cables for the VPN Router Connecting communications cablesCabling the VPN Router and turning the power on Rear view of the VPN Router Requirement Description Connecting the power cordPower cord requirements Verifying a successful installation Indicator Description Front panel LED indicatorsUnderstanding the LEDs Front panel LEDsLEDs on the system 10/100BASE-TX Ethernet port LED indicators on the system 10/100BASE-TX Ethernet port1000BASE-T 1000 GT Ethernet interface card LEDs LED indicators on the 10/100BASE-TX Ethernet interface card10/100BASE-TX Ethernet interface card LEDs LEDs on the 1000BASE-T 1000 MT Ethernet interface card 1000BASE-T 1000 MT Ethernet interface card LEDs1000BASE-SX Ethernet interface card LED LED indicator on the 1000BASE-SX Ethernet interface card56/64K CSU/DSU WAN interface card LEDs LED indicators on the 56/64K CSU/DSU WAN interface cardTx/Rx LED Description LED indicators on the Adsl WAN interface cardAdsl WAN interface card LEDs T1/E1 CSU/DSU WAN interface card LEDs LED indicators on the T1/E1 CSU/DSU WAN interface cardQuad T1/E1 CSU/DSU WAN interface card LEDs LED indicators on the quad T1/E1 CSU/DSU WAN interface cardSingle V.35/X.21 WAN interface card LEDs LED indicators on the single V.35/X.21 WAN interface cardSSL VPN Module 1000 LEDs LED indicators on the SSL VPN ModuleLEDs Indicator Description Chapter Configuring the management IP interface Required information Configuring the management IP interfaceConfiguring the management IP address Enter Old Subnet Mask = 0.0.0.0 New Subnet Mask = Type M, and press Enter Management IP Address prompt appears Testing the configuration Troubleshooting Chapter Installing option cards and DIMMs Shutting down the system to add or replace hardware Installing option cards and DIMMsRemoving the front bezel and top cover Slide the top cover forward approximately 1/4 inch Location of option card slots and DIMMs on the system board Attaching the antistatic wrist strap Maximum Option card Number Restrictions Installing and replacing option cardsSupported option cards for the 2600 Option card Restrictions with SSL VPN Module 1000 installed Installing other option cards with the SSL VPN Module1000BASE-T or 1000BASE-SX interface Installing and removing an option card Press here Installing and replacing DIMMs Installing option cards and DIMMs Installing and removing a Dimm Installing option cards and DIMMs Installing option cards and DIMMs NN46110-311 Chassis specifications Appendix a Technical specificationsPhysical, electrical, and environmental specifications Specification Description10/100BASE-TX Ethernet LAN port System portsSerial port Appendix a Technical specifications10/100BASE-TX Ethernet port pinouts Pin DescriptionSerial port DB9 connector DB25 connector Modem cable specificationsMultiple DB9 and DB25 connector pinouts Modem cable pinouts Nortel termination Modem termination Signal Pin # to Pin #Hardware option cards VPN Router Security Accelerator card VPN Router Security Accelerator cardsSSL VPN Module SSL VPN Module10/100BASE-TX Ethernet interface card 10/100BASE-TX Ethernet interface card1000BASE-T 1000 GT Ethernet interface card 1000BASE-T 1000 GT Ethernet pinouts 1000BASE-T 1000 GT Ethernet interface card1000BASE-T 1000 MTEthernet port pinouts 1000BASE-T 1000 MT Ethernet interface cardNN46110-311 1000BASE-SX Ethernet interface card 1000BASE-SX Ethernet interface card56/64K CSU/DSU WAN interface card 56/64K CSU/DSU WAN interface card56/64K CSU/DSU cable pinouts for straight-through connection Nortel termination Remote termination Signal Pin # to Pin #Pin Function Adsl WAN interface cardAdsl cable pinouts Isdn BRI S/T cable pinouts Isdn BRI interface cardIsdn BRI U cable pinouts T1/E1 CSU/DSU WAN interface cardT1/E1 CSU/DSU cable pinouts for crossover connection T1/E1 CSU/DSU WAN interface card full-height cardT1/E1 CSU/DSU cable pinouts for straight-through connection Quad T1/E1 CSU/DSU WAN interface card Quad T1/E1 CSU/DSU WAN interface card90 modem cable pinouts Modem interface cardSingle V.35/X.21 WAN interface card 35 cable pinouts 21 cable pinouts Appendix a Technical specifications 35 cable pinoutsAppendix a Technical specifications 21 cable pinouts T3 cable pinouts Pin Scsi male Signal nameHssi WAN interface card GND RCA CAA RDA LCA STA TAA TTA LAA TDA LBA Testa Appendix a Technical specifications NN46110-311 Numerics IndexIndex Index Index Index Index
Related manuals
Manual 12 pages 5.25 Kb