Nortel Networks 2700 manual Installing other option cards with the SSL VPN Module

Page 66

66Chapter 4 Installing option cards and DIMMs

Table 16 Supported option cards for the 2600 and 2700

 

Maximum

 

Option card

number

Restrictions

 

 

 

V.90 modem interface

4

If an SSL VPN Module 1000 is in slot 1, do not

 

 

install the V.90 modem interface card in slot 2.

Single V.35/X.21 WAN interface

4

 

(full-height)

 

 

Single V.35/X.21 WAN interface

4

 

(half-height)8

 

 

HSSI WAN interface9

2

Do not install in slot 4; install in slot 3 or 1 if possible.

 

 

If an SSL VPN Module 1000 is installed, you can

 

 

install only one HSSI WAN interface card.

1The VPN Router 2700 must be running Version 5.0 or later.

2The VPN Router 2700 must be running Version 4.90 or later.

3To support two Hardware Accelerator cards, the gateway must be running Version 4.76 or later.

4The VPN Router 2700 must be running Version 5.05.330, 6.05.140 and later, 7.00.062, 7.05.100 and later, or 7.05.300 and later. The VPN Router 2600 supports 10/100 Mbps operation only.

5The VPN Router 2700 must be running Version 5.0 or later.

6The VPN Router 2700 must be running Version 4.90 or later.

7The VPN Router 2700 must be running Version 4.80 or later.

8The VPN Router 2700 must be running Version 4.80 or later.

9The gateway must be running Version 4.76 or later, or the hardware revision must be at least 03.

Table 17 provides additional guidelines for option card installation when an SSL VPN Module 1000 is installed in slot 1.

Table 17 Installing other option cards with the SSL VPN Module 1000

Option card

Restrictions with SSL VPN Module 1000 installed

 

 

VPN Router Security Accelerator

Only one VPN Router Security Accelerator card can be

 

installed.

Hardware Accelerator

You can install two cards only if none of these cards is installed:

 

• VPN Router Security Accelerator

 

1000BASE-T or 1000BASE-SX

 

HSSI

 

If a 1000BASE-T (1000 MT), 1000BASE-SX, Security

 

Accelerator, or HSSI card is installed, only one Hardware

 

Accelerator card can be installed.

NN46110-311 02.01

Image 66
Contents Nortel VPN Router Installation Copyright 2007 Nortel Networks. All rights reserved NN46110-311Nortel VPN Router Installation VPN Router EC Declaration of ConformityCanada requirements only General NN46110-311 Contents Chapter Cabling the VPN Router and turning the power on ContentsAppendix a Contents NN46110-311 Figures Figures Tables Tables Features New in this release1000BASE-T 1000 GT Ethernet card New in this release NN46110-311 How to get help Finding the latest updates on the Nortel Web siteGetting help from the Nortel Web site Getting help over the phone from a Nortel Solutions Center How to get helpGetting help through a Nortel distributor or reseller How to get help NN46110-311 Preface Before you beginText conventions AcronymsPreface Related publications Nortel VPN Router Security Firewalls, Filters, NAT, and QoSPrinted technical manuals Chapter Installing the Nortel VPN Router 2700 chassis Description of the Nortel VPN RouterTopic Preparing to install the Nortel VPN Router Installing the Nortel VPN Router 2700 chassisShipment contents Additional equipment Site requirementsInstalling the chassis Installing the chassis on a flat surfaceInstalling the chassis in an equipment rack Rack-mount recommendationsAttaching the cage nuts to the rack Mounting the chassis in the equipment rack Replacing the front bezel Installing the Nortel VPN Router 2700 chassis NN46110-311 Chapter Cabling the VPN Router and turning the power on TopicConnecting communications cables Cabling the VPN Router and turning the power onInterfaces and cables for the VPN Router Rear view of the VPN Router Connecting the power cord Power cord requirementsRequirement Description Verifying a successful installation Understanding the LEDs Front panel LED indicatorsIndicator Description Front panel LEDsLED indicators on the system 10/100BASE-TX Ethernet port LEDs on the system 10/100BASE-TX Ethernet portLED indicators on the 10/100BASE-TX Ethernet interface card 10/100BASE-TX Ethernet interface card LEDs1000BASE-T 1000 GT Ethernet interface card LEDs 1000BASE-T 1000 MT Ethernet interface card LEDs LEDs on the 1000BASE-T 1000 MT Ethernet interface cardLED indicator on the 1000BASE-SX Ethernet interface card 1000BASE-SX Ethernet interface card LEDLED indicators on the 56/64K CSU/DSU WAN interface card 56/64K CSU/DSU WAN interface card LEDsLED indicators on the Adsl WAN interface card Adsl WAN interface card LEDsTx/Rx LED Description LED indicators on the T1/E1 CSU/DSU WAN interface card T1/E1 CSU/DSU WAN interface card LEDsLED indicators on the quad T1/E1 CSU/DSU WAN interface card Quad T1/E1 CSU/DSU WAN interface card LEDsLED indicators on the single V.35/X.21 WAN interface card Single V.35/X.21 WAN interface card LEDsLED indicators on the SSL VPN Module LEDs Indicator DescriptionSSL VPN Module 1000 LEDs Chapter Configuring the management IP interface Configuring the management IP interface Required informationConfiguring the management IP address Enter Old Subnet Mask = 0.0.0.0 New Subnet Mask = Type M, and press Enter Management IP Address prompt appears Testing the configuration Troubleshooting Chapter Installing option cards and DIMMs Installing option cards and DIMMs Shutting down the system to add or replace hardwareRemoving the front bezel and top cover Slide the top cover forward approximately 1/4 inch Location of option card slots and DIMMs on the system board Attaching the antistatic wrist strap Installing and replacing option cards Supported option cards for the 2600Maximum Option card Number Restrictions Installing other option cards with the SSL VPN Module Option card Restrictions with SSL VPN Module 1000 installed1000BASE-T or 1000BASE-SX interface Installing and removing an option card Press here Installing and replacing DIMMs Installing option cards and DIMMs Installing and removing a Dimm Installing option cards and DIMMs Installing option cards and DIMMs NN46110-311 Physical, electrical, and environmental specifications Appendix a Technical specificationsChassis specifications Specification DescriptionSystem ports 10/100BASE-TX Ethernet LAN port10/100BASE-TX Ethernet port pinouts Appendix a Technical specificationsSerial port Pin DescriptionModem cable specifications Multiple DB9 and DB25 connector pinoutsSerial port DB9 connector DB25 connector Nortel termination Modem termination Signal Pin # to Pin # Hardware option cardsModem cable pinouts VPN Router Security Accelerator cards VPN Router Security Accelerator cardSSL VPN Module SSL VPN Module10/100BASE-TX Ethernet interface card 10/100BASE-TX Ethernet interface card1000BASE-T 1000 GT Ethernet interface card 1000BASE-T 1000 GT Ethernet interface card 1000BASE-T 1000 GT Ethernet pinouts1000BASE-T 1000 MT Ethernet interface card 1000BASE-T 1000 MTEthernet port pinoutsNN46110-311 1000BASE-SX Ethernet interface card 1000BASE-SX Ethernet interface card56/64K CSU/DSU WAN interface card 56/64K CSU/DSU WAN interface cardNortel termination Remote termination Signal Pin # to Pin # 56/64K CSU/DSU cable pinouts for straight-through connectionAdsl WAN interface card Adsl cable pinoutsPin Function Isdn BRI interface card Isdn BRI S/T cable pinoutsT1/E1 CSU/DSU WAN interface card Isdn BRI U cable pinoutsT1/E1 CSU/DSU WAN interface card full-height card T1/E1 CSU/DSU cable pinouts for crossover connectionT1/E1 CSU/DSU cable pinouts for straight-through connection Quad T1/E1 CSU/DSU WAN interface card Quad T1/E1 CSU/DSU WAN interface cardModem interface card Single V.35/X.21 WAN interface card90 modem cable pinouts 35 cable pinouts Appendix a Technical specifications 35 cable pinouts 21 cable pinoutsAppendix a Technical specifications 21 cable pinouts Pin Scsi male Signal name Hssi WAN interface cardT3 cable pinouts GND RCA CAA RDA LCA STA TAA TTA LAA TDA LBA Testa Appendix a Technical specifications NN46110-311 Index NumericsIndex Index Index Index Index
Related manuals
Manual 12 pages 5.25 Kb