Nortel Networks 2700 manual System ports, 10/100BASE-TX Ethernet LAN port

Page 76

76Appendix A Technical specifications

Table 18 Physical, electrical, and environmental specifications (continued)

Specification

Description

 

 

Operating altitude

7000 ft (2133.6 m) maximum

 

 

Storage altitude

40,000 ft (12,192 m) maximum

 

 

System ports

The VPN Router 2700 system board provides the following built-in interfaces:

10/100BASE-TX Ethernet LAN port

serial port

This section provides information about the 10/100BASE-TX Ethernet LAN port and the serial port on the system board.

10/100BASE-TX Ethernet LAN port

The system board provides one 10/100BASE-TX Ethernet LAN interface on the rear of the chassis. Use this LAN interface, which accommodates an RJ-45 straight- through cable, for Web management. Depending on whether you use the interface for 10BASE-T or 100BASE-TX operation, select cables for the interface as follows:

100BASE-TX connections require Category 5 twisted-pair wire. The 100BASE-TX specification supports 100 Mb/s transmission over two pairs of Category 5 twisted-pair Ethernet wiring: one pair each for transmit and receive operations.

Nortel recommends a maximum length of 100 meters for the cable segment between a 100BASE-TX repeater and a workstation (due to signal timing requirements). This wiring scheme complies with the EIA 568 wiring standard.

10BASE-T connections can use Category 3, 4, or 5 twisted-pair wiring.

Figure 27 shows the 10/100BASE-TX connector and the connector pinouts.

NN46110-311 02.01

Image 76
Contents Nortel VPN Router Installation Copyright 2007 Nortel Networks. All rights reserved NN46110-311Nortel VPN Router Installation VPN Router EC Declaration of ConformityCanada requirements only General NN46110-311 Contents Chapter Cabling the VPN Router and turning the power on ContentsAppendix a Contents NN46110-311 Figures Figures Tables Tables New in this release Features1000BASE-T 1000 GT Ethernet card New in this release NN46110-311 Finding the latest updates on the Nortel Web site How to get helpGetting help from the Nortel Web site Getting help over the phone from a Nortel Solutions Center How to get helpGetting help through a Nortel distributor or reseller How to get help NN46110-311 Preface Before you beginAcronyms Text conventionsPreface Related publications Nortel VPN Router Security Firewalls, Filters, NAT, and QoSPrinted technical manuals Description of the Nortel VPN Router Chapter Installing the Nortel VPN Router 2700 chassisTopic Preparing to install the Nortel VPN Router Installing the Nortel VPN Router 2700 chassisShipment contents Additional equipment Site requirementsInstalling the chassis Installing the chassis on a flat surfaceInstalling the chassis in an equipment rack Rack-mount recommendationsAttaching the cage nuts to the rack Mounting the chassis in the equipment rack Replacing the front bezel Installing the Nortel VPN Router 2700 chassis NN46110-311 Chapter Cabling the VPN Router and turning the power on TopicCabling the VPN Router and turning the power on Connecting communications cablesInterfaces and cables for the VPN Router Rear view of the VPN Router Power cord requirements Connecting the power cordRequirement Description Verifying a successful installation Front panel LED indicators Indicator DescriptionUnderstanding the LEDs Front panel LEDsLED indicators on the system 10/100BASE-TX Ethernet port LEDs on the system 10/100BASE-TX Ethernet port10/100BASE-TX Ethernet interface card LEDs LED indicators on the 10/100BASE-TX Ethernet interface card1000BASE-T 1000 GT Ethernet interface card LEDs 1000BASE-T 1000 MT Ethernet interface card LEDs LEDs on the 1000BASE-T 1000 MT Ethernet interface cardLED indicator on the 1000BASE-SX Ethernet interface card 1000BASE-SX Ethernet interface card LEDLED indicators on the 56/64K CSU/DSU WAN interface card 56/64K CSU/DSU WAN interface card LEDsAdsl WAN interface card LEDs LED indicators on the Adsl WAN interface cardTx/Rx LED Description LED indicators on the T1/E1 CSU/DSU WAN interface card T1/E1 CSU/DSU WAN interface card LEDsLED indicators on the quad T1/E1 CSU/DSU WAN interface card Quad T1/E1 CSU/DSU WAN interface card LEDsLED indicators on the single V.35/X.21 WAN interface card Single V.35/X.21 WAN interface card LEDsLEDs Indicator Description LED indicators on the SSL VPN ModuleSSL VPN Module 1000 LEDs Chapter Configuring the management IP interface Configuring the management IP interface Required informationConfiguring the management IP address Enter Old Subnet Mask = 0.0.0.0 New Subnet Mask = Type M, and press Enter Management IP Address prompt appears Testing the configuration Troubleshooting Chapter Installing option cards and DIMMs Installing option cards and DIMMs Shutting down the system to add or replace hardwareRemoving the front bezel and top cover Slide the top cover forward approximately 1/4 inch Location of option card slots and DIMMs on the system board Attaching the antistatic wrist strap Supported option cards for the 2600 Installing and replacing option cardsMaximum Option card Number Restrictions Installing other option cards with the SSL VPN Module Option card Restrictions with SSL VPN Module 1000 installed1000BASE-T or 1000BASE-SX interface Installing and removing an option card Press here Installing and replacing DIMMs Installing option cards and DIMMs Installing and removing a Dimm Installing option cards and DIMMs Installing option cards and DIMMs NN46110-311 Appendix a Technical specifications Chassis specificationsPhysical, electrical, and environmental specifications Specification DescriptionSystem ports 10/100BASE-TX Ethernet LAN portAppendix a Technical specifications Serial port10/100BASE-TX Ethernet port pinouts Pin DescriptionMultiple DB9 and DB25 connector pinouts Modem cable specificationsSerial port DB9 connector DB25 connector Hardware option cards Nortel termination Modem termination Signal Pin # to Pin #Modem cable pinouts VPN Router Security Accelerator cards VPN Router Security Accelerator cardSSL VPN Module SSL VPN Module10/100BASE-TX Ethernet interface card 10/100BASE-TX Ethernet interface card1000BASE-T 1000 GT Ethernet interface card 1000BASE-T 1000 GT Ethernet interface card 1000BASE-T 1000 GT Ethernet pinouts1000BASE-T 1000 MT Ethernet interface card 1000BASE-T 1000 MTEthernet port pinoutsNN46110-311 1000BASE-SX Ethernet interface card 1000BASE-SX Ethernet interface card56/64K CSU/DSU WAN interface card 56/64K CSU/DSU WAN interface cardNortel termination Remote termination Signal Pin # to Pin # 56/64K CSU/DSU cable pinouts for straight-through connectionAdsl cable pinouts Adsl WAN interface cardPin Function Isdn BRI interface card Isdn BRI S/T cable pinoutsT1/E1 CSU/DSU WAN interface card Isdn BRI U cable pinoutsT1/E1 CSU/DSU WAN interface card full-height card T1/E1 CSU/DSU cable pinouts for crossover connectionT1/E1 CSU/DSU cable pinouts for straight-through connection Quad T1/E1 CSU/DSU WAN interface card Quad T1/E1 CSU/DSU WAN interface cardSingle V.35/X.21 WAN interface card Modem interface card90 modem cable pinouts 35 cable pinouts Appendix a Technical specifications 35 cable pinouts 21 cable pinoutsAppendix a Technical specifications 21 cable pinouts Hssi WAN interface card Pin Scsi male Signal nameT3 cable pinouts GND RCA CAA RDA LCA STA TAA TTA LAA TDA LBA Testa Appendix a Technical specifications NN46110-311 Index NumericsIndex Index Index Index Index
Related manuals
Manual 12 pages 5.25 Kb