MGE UPS Systems 100 installation manual Configuring the RS485 card for Comet, For Comet

Page 21

2. Installation

Configuring the RS485 card for Comet

The settings proposed below comply with the recommended configuration (see section "Single-unit type installation"). They must be made before installing and commissioning the PowerServices TelPac external unit.

The slave number is set to 1 by default. Parameters may be set using UPS Tuner or Soft-Tunor.

XM1

XM2

JOJO 6761294

OFF

Configuration

for Comet

XM5

XM3

XM4

34003602EN/AB - Page 21

Image 21

Contents

Installation manual PowerServicesTM TelPac2 34003602EN/AB Introduction Special precautionsEnvironment Recycling of packagingEMC compatibility ForewordFederal Communication Commission FCC statement Radio and Telecommunications compatibilityList of countries supported by the modem Modem compatibility and supported countriesPictogram symbols Contents Maintenance Presentation Unpacking and checking the contentsOverview Functions Country Teleservice CentrePower supply Technical data sheetRS485 Port ModemIndicator lights Status Green UPS indicator Card version External versionStatus Red CD indicator Card version External version Installation ProcedurePreliminary check Various installation types Fitting the warning label RecommendationsGalaxy PW MGE Attention Onduleur sous TeleserviceSingle-unit type installation Setting up the RS485 linkGeneral UPS with JbusImpedance matching and bias settings = Shielding Configuring the shielding terminalFor Comet Configuring the RS485 card for CometConfiguring the Rauz card for Galaxy Connection Installing the PowerServices TelPac cardConnections Comet S31 7.5/10KVAComet S31 15/20KVA Open the doors giving access to Galaxy view with doors open and protective panels in place PowerServices TelPac card 2 inputs Connecting contact type inputs5V B PowerServices TelPac external unit 2 inputs + 4 extensionsMaintenance Cable diagramsComet link cable ref