PowerServices TelPac external unit (2 inputs + 4 extensions)
C
D
E
F 
< 10m
Extension
2. Installation
Four similar inputs C, D, E, F are available inside the external unit on terminal block XM13.
To connect contacts to these four inputs, proceed as follows:
◗Remove the cover (partly unscrew the screws and pivot the cover).
◗Remove the card from the external unit (3 screws).
◗Feed the cable through the grommet. ◗Connect the cable(s) to terminal block XM13 as shown in the figure opposite.
Terminal block XM13
Phone | JBUS / RS485 |
Settings | |
CD | A 5V B R+ R- T+ T- |
UPS | TelPac |
|
A 5V B
◗Replace the card in the external unit and fix it in place (3 screws).
◗Replace the cover.
PowerServices TelPac is now ready for the parameter setting stage required for Teleservice. Consult the Technical Support documentation. Lastly, move on to step 2 (see section 2.1 "Procedure").
34003602EN/AB - Page 29