American Power Conversion SURT15000, 20000 VA user manual Connect PowerView

Page 8

Connect PowerView

Connect the PowerView cable to the PowerView connector on UPS.

Route ethernet cable and install top cover and bezels

There are three ways to access the ethernet port on this unit:

1.Rear panel access utilizing ethernet jumper cable on front panel

2.Front panel access routing ethernet cable under top cover

3.Front panel access routing ethernet cable through bezel notch

Rear panel access utilizing ethernet jumper cable on front panel

Locate the RJ45 connector and the ethernet port on the front panel of the UPS. Connect the ethernet jumper cable (included), to the RJ45 connector and the ethernet port.

Connect a network cable (not included), to the RJ45 connector on the rear panel of the UPS.

Ethernet Cable connected to Rear Panel

RJ45 Connector

RJ45

Connector

Ethernet Cable

Ethernet Port

Ethernet

Jumper

Cable

Internal Pass Through Ethernet Cable Connecting

Front and Rear Panel RJ45 Connectors

4	Smart-UPS RT 15000/20000 VA 230 Vac UXI/UXICH Tower User Manual

Image 8

Contents UXI/UXICH Page Contents Page Unpack package contents About this UPSSpecifications Environmental SpecificationsInstallation Install PowerViewConnect PowerView Route ethernet cable and install top cover and bezelsFront panel access routing ethernet cable under top cover Accessories Optional accessoriesInstall input and output wiring trays in UPS rear panel Wiring Specifications Adhere to national and local electrical codes when wiringInput wiring options Input/Output Jumper ConfigurationsSingle phase input, single phase output, single feed Single phase input, single phase output, dual feedThree phase input, single phase output, single feed Three phase input, three phase output, single feedThree phase input, single phase output, dual feed Three phase input, three phase output, dual feedOutput wiring options L3 L2 L1 OSJBattery Safety APC battery solutionQualified electrician should perform the installation Servicing of external batteriesThird party battery solution Each battery system must have identical Amp-hrsPowerView Interface Display Battery operationOperation Normal operationNavigating menu screens Main Menu ScreenMenu Tree Navigating sub menu screensSub menu screens SystemView Log Communication Ports Connect power to UPS and loadConnect load to UPS Emergency Power Off EPO EPO ConnectorInput/Output Jumper Configurations Page Refer to Contact Information in this Option 2 Correct bypass input Service and Transport Warranty claims Regulatory Agency Approvals Models