American Power Conversion 20000 VA, SURT15000 user manual Installation, Install PowerView

Page 7

	Installation
	Tower front panel
		Interface Display
	PowerView	Ethernet Port 10/100 Base-T
	RJ45 Connector (pass through	Ethernet Port 10/100 Base-T
	RJ45 Connector (pass through
	to Rear Panel RJ45 Connector	SmartSlot with Network
		SmartSlot with Network
	Serial Port	Management Card
	Serial Port
	PowerView Cable Connector	Cold Start/EPO reset

Install PowerView

Prior to attaching the PowerView to the UPS:

1.Loosen the two bracket screws on the back of the PowerView module.

a.Slide the bracket to the position that will accommodate the screw holes on the UPS.

b.Tighten the screws on the bracket.

2.Secure the PowerView to the UPS using the two thumb screws attached to the PowerView.

Smart-UPS RT 15000/20000 VA 230 Vac UXI/UXICH Tower User Manual

3

Image 7

Contents UXI/UXICH Page Contents Page About this UPS Unpack package contentsEnvironmental Specifications SpecificationsInstall PowerView InstallationRoute ethernet cable and install top cover and bezels Connect PowerViewFront panel access routing ethernet cable under top cover Optional accessories AccessoriesInstall input and output wiring trays in UPS rear panel Adhere to national and local electrical codes when wiring Wiring SpecificationsInput/Output Jumper Configurations Input wiring optionsSingle phase input, single phase output, dual feed Single phase input, single phase output, single feedThree phase input, three phase output, dual feed Three phase input, single phase output, single feedThree phase input, three phase output, single feed Three phase input, single phase output, dual feedL3 L2 L1 OSJ Output wiring optionsServicing of external batteries Battery SafetyAPC battery solution Qualified electrician should perform the installationEach battery system must have identical Amp-hrs Third party battery solutionNormal operation PowerView Interface DisplayBattery operation OperationMain Menu Screen Navigating menu screensNavigating sub menu screens Menu TreeSystem Sub menu screensView Log Connect load to UPS Connect power to UPS and loadCommunication Ports EPO Connector Emergency Power Off EPOInput/Output Jumper Configurations Page Refer to Contact Information in this Option 2 Correct bypass input Service and Transport Warranty claims Models Regulatory Agency Approvals