Agilent Technologies 66lxxA manual Outpprotcle Outpprotdel 75E-1, Outprelpol, Norm

OUTP:PROT:DEL Sets the delay time between the programming of an output change that produces a CV, CC, or UNREG condition and the recording of that condition by the Status Operation Condition register. The delay prevents momentary changes in power module status that can occur during reprogramming from being registered as events by the status subsystem. Since the delay applies to CC status, it also delays the OCP (overcurrent protection) feature. The OVP (overvoltage protection) feature is not affected by this delay.

Command Syntax	OUTPut:PROTection:CLEar
	OUTPut:PROTection:DELay <NRf+>
Parameters	OUTP:PROT:CLE,	(none)
	OUTP:PROT:DEL	0 to 32.767 MIN MAX
Default Suffix	S
*RST Value	100 (milliseconds)
Examples	OUTP:PROT:CLE OUTP:PROT:DEL 75E-1
Query Syntax	OUTP:PROTection:CLEar (None)
	OUTPut:PROTection:DELay?
	OUTPut:PROTection:DELay? MINimum
	OUTPut:PROTection:DELay? MAXimum
Returned Parameters	<NR3>
Related Commands	OUTP:PROT:CLE (None)
	OUTP:PROT:DEL	*RCL *SAV

OUTP:REL

This command is valid only if the power module is configured for the optional relay connector. Programming ON closes the relay contacts; programming OFF opens them. The relay is controlled independently of the output state. If the power module is supplying power to a load, that power will appear at the relay contacts during switching. If the power module is not configured for the relay connector, sending either relay command generates an error.

Command Syntax	OUTPut:RELay[:STATe] <bool>
Parameters	0	1 OFF ON
*RST Value	0
Examples	OUTP:REL 1		OUTP:REL OFF
Query Syntax	OUTPut:RELay?
Returned Parameters	0	1
Related Commands	OUTP[:STAT]		*RCL *SAV

OUTP:REL:POL

This command is valid only if the power module is configured for the optional relay connector. Programming NORMal causes the relay output polarity to be the same as the power module output. Programming REVerse causes the relay output polarity to be opposite to that of the power module output. If OUTP[:STAT] = ON when either relay command is sent, the power module output voltage is set to 0 during the time that the relays are changing polarity. If the power module is not configured for the relay connector, sending either relay command generates an error.

Command Syntax	OUTPut:RELay:POLarity <CRD>
Parameters	NORMal REVerse
*RST Value	NORM
Examples	OUTP:REL:POL	NORM
Query Syntax	OUTPut:RELay:POLarity?
Returned Parameters	NORM REV
Related Commands	OUTP[:STAT]	*RCL *SAV

Language Dictionary 41