Ricoh SP C250SF, SP C252SF Problem Solution, Cleaning the Registration Roller and Paper Tray, 307

		Paper Feed Problems
Problem		Solution
Multiple sheets of paper are fed at	•	Fan the paper well before loading. Also make sure that
once.		the edges are aligned by tapping the stack on a flat
		surface such as a desk.
	• Make sure that the paper guides are in the right position.
	•	Use supported types of paper. See page 57 "Supported
		Paper".
	• Load paper only as high as the upper limit markings on
		the paper guide.
	• Make sure that the friction pads, paper feed rollers or
		registration rollers are clean. See page 288 "Cleaning
		the Friction Pad and Paper Feed Roller" and page 291
		"Cleaning the Registration Roller and Paper Tray".
	• Check that paper was not added while there was still
		some left in the tray.
		Only add paper when there is none left in the tray.
The printed paper is wrinkled.	•	The paper being used may be damp. Use paper that has
		been stored properly. See page 57 "Supported Paper".
	•	Paper is too thin. See page 57 "Supported Paper".
	•	If there are gaps between the paper and the paper
		guides, adjust the paper guides to remove the gaps.
	• Check that both the left and right fusing unit levers have
		been raised to the plain paper mark.
The printed paper is curled.	•	Load the paper upside down in the paper tray.
	• If the paper curl is severe, retrieve prints from the output
		tray more frequently.
	•	The paper being used may be damp. Use paper that has
		been stored properly. See page 57 "Supported Paper".
	• Select [Lvl.2: Medium] or [Lvl.3: Strong] in [Anti-Humidity
		Level] under [System Settings]. Note that if you select [Lvl.
		2: Medium] or [Lvl.3: Strong], the first print takes longer
		than subsequent prints.

307