Ricoh SP C250SF, SP C252SF operating instructions When an Error Is Notified via a Report or E-mail

		Fax Problems
Problem	Causes	Solutions
The background of received	Image density is too high.	Adjust the image density. See
images appears dirty.		page 136 "Specifying the Scan
Images from the back of the		Settings".
page appear.
Received image is too light.	When using moist, rough, or	Use the recommended paper. For
	processed paper, areas of	details about the recommended paper,
	print may not be fully	see page 57 "Supported Paper".
	reproduced.
	The image density has been	Increase the image density. For details
	specified too low.	about how to change the density, see
		page 118 "Adjusting Image Density".
	The original of the	Ask the sender to reprint the original on
	transmitted fax was printed	thicker paper, and then fax it again.
	on paper that is too thin.

When an Error Is Notified via a Report or E-mail

When a report is printed from the machine

Error Report

An Error Report is printed if a document cannot be successfully sent or received.

Possible causes include a problem with the machine or noise on the telephone line. If an error occurs during transmission, resend the original. If an error occurs during reception, ask the sender to resend the document.

•If an error happens frequently, contact your service representative.

•The "Page" column gives the total number of pages.

Power Failure Report

•Right after recovery from power failure, the internal battery needs to be sufficiently recharged to guard against future data loss. Keep the machine plugged in and the power on for about 24 hours after the power loss.

Even if the power is turned off, the contents of the machine memory (for example, programmed numbers) will not be lost. Lost items will include any fax documents stored in memory using Memory Transmission or Reception.

If a file deleted from memory, Power Failure Report is automatically printed as soon as the power is restored.

327