Coda Cold-Mount Laminator operation manual Adjusting the Rollers for Even Pressure

Page 7

Adjusting the Rollers for Even Pressure

Using the gap adjusting knobs, lower the right side of the top roller so that it almost touches the bottom roller.

Then do the same on the left side.

Figure 7

Next make the fine adjustment on the right by turning the gap adjusting knob clockwise until the rollers just touch. Then do the same on the left side until the rollers are parallel.

Figure 8

Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133

Email: sales@codamount.com	www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual	January 2006

Image 7

Contents Coda Cold-Mount Laminator Operation Guide Instructions Cold-Mount Laminator Operation Guide IndexLaminator Set-Up Laminator Set-Up Location and Function of Controls Setting the Spring Pressure Adjusting the Rollers for Even Pressure Roller Alignment Procedure Setting the Roller Gap Basic Cold-MountProcedure Basic Cold-MountProcedure Congratulations you have successfully mounted a print Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Optional Heavy Duty Roll Feed Heavy Duty Roll FeedTo attach the Heavy Duty Roll Feed to the Laminator Heavy Duty Roll Feed AssemblyShows the Heavy Duty Roll Feed assembled to a 26 Laminator Laminating with the Heavy Duty Roll Feed Laminating with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coda Cold-Mount System Coda Cold Pressure Sensitive Laminates Coda Mounting Adhesives Coda Pre-Coated Boards Coda Accessories