Coda Cold-Mount Laminator operation manual Basic Cold-MountProcedure

Page 11

Basic Cold-Mount®Procedure (continued)

Use hand tension to wrap the print around the top roller. Make sure there are no gaps between the print and the roller.

Figure 16

Peel off the release liner. Run the print and the substrate through the laminator, taking care not to let the print flop down on the adhesive.

Figure 17

Always keep an even tight tension on the print to avoid any wrinkling. The print will come out perfectly mounted.

Figure 18

Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133

Email: sales@codamount.com	www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual	January 2006

Image 11

Contents Coda Cold-Mount Laminator Operation Guide Instructions Cold-Mount Laminator Operation Guide IndexLaminator Set-Up Laminator Set-Up Location and Function of Controls Setting the Spring Pressure Adjusting the Rollers for Even Pressure Roller Alignment Procedure Setting the Roller Gap Basic Cold-MountProcedure Basic Cold-MountProcedure Congratulations you have successfully mounted a print Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Optional Heavy Duty Roll Feed Heavy Duty Roll FeedTo attach the Heavy Duty Roll Feed to the Laminator Heavy Duty Roll Feed AssemblyShows the Heavy Duty Roll Feed assembled to a 26 Laminator Laminating with the Heavy Duty Roll Feed Laminating with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coda Cold-Mount System Coda Cold Pressure Sensitive Laminates Coda Mounting Adhesives Coda Pre-Coated Boards Coda Accessories