Coda Cold-Mount Laminator operation manual Laminating a Print with a Sheeted Laminate

Page 14

Laminating a Print with a Sheeted Laminate (continued)

Start the laminator while holding the release liner and run it as slow as possible. Running slow applies the pressure for a longer period of time across the entire width which will result in a better adhesion of the laminate to the print.

Figure 22

Be sure to hold the release liner, peeling it back slowly as the laminate is fed into the laminator. Be careful not to allow the release liner to feed into the laminator and get pinched between the rollers.

Figure 23

Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133

Email: sales@codamount.com	www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual	January 2006

Image 14

Contents Coda Cold-Mount Laminator Operation Guide Cold-Mount Laminator Operation Guide Index InstructionsLaminator Set-Up Laminator Set-Up Location and Function of Controls Setting the Spring Pressure Adjusting the Rollers for Even Pressure Roller Alignment Procedure Setting the Roller Gap Basic Cold-MountProcedure Basic Cold-MountProcedure Congratulations you have successfully mounted a print Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Laminating a Print with a Sheeted Laminate Heavy Duty Roll Feed Optional Heavy Duty Roll FeedHeavy Duty Roll Feed Assembly To attach the Heavy Duty Roll Feed to the LaminatorShows the Heavy Duty Roll Feed assembled to a 26 Laminator Laminating with the Heavy Duty Roll Feed Laminating with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coating Boards with the Heavy Duty Roll Feed Coda Cold-Mount System Coda Cold Pressure Sensitive Laminates Coda Mounting Adhesives Coda Pre-Coated Boards Coda Accessories