Operations Manual: Installation
Voyager3
4.0 Installation
CAUTION: The GBC Voyager 3 can only be installed by a trained GBC Service Representative.
Before a Voayger 3 Laminator can be installed, there are a few requirements that must be met. Make cer- tain that each of the requirements listed in the fol- lowing
CAUTION: Failure to follow the
As a customer, you are responsible for ensuring the crates are uncrated and the components are set in proper position as illustrated in Figure 4.1.1 Suggested Floor Layout. The installation time is out- lined to allow for maximum hands on training with the operators.
4.1 Pre-installation
Are the doorways and hallways wide enough for the laminator to be moved to the installa- tion site?
Is there ample room for the laminator? The laminator occupies 16 ft. by 6 ft. of floor space (488 cm x 183 cm).
A safe work area constitutes enough room to work with the materials at hand while being free to move around the laminator without interference from the laminator. You must allow a minimum of 5 ft. (152 cm) in front of the feeder and on the operator side, and a minimum of 2 ft. (61 cm) behind the stacker and drive side of the laminator. Refer to Figure 4.1.1 Floor layout.
Is the environment appropriate for the laminator? A controlled environment is recom- mended.
CAUTION: The operating environment must be free of dust, flammable liquids and vapors.
The laminator requires a clean, dust and vapor free environment to operate properly.
2004 General Binding Corporation | Page |