Voyager3
Operations Manual: Installation
CAUTION: Do not locate the laminator where air can blow directly on the machine. The air flow can cool the rollers unevenly and result in poor quality output.
Have you contacted a certified electrician to install a receptacle for the laminator ensuring that adequate power and correct circuit breaker is being supplied?
The laminator and heater requires 380 Volt AC, 50/ 60 Hz, 50 amps, Delta three phase (four wire) power. For US, a transformer is required to step up power from 230 Volt 3 Phase to 380 Volt 3 Phase AC. Refer to Figure 4.1.2 connections.
For heater requirements, consult the heater manual for your unit.
INFORMATION: The vacuum/ pump, feeder and heater units will draw it’s electrical power from the laminator.
Is tap and drain water available?
Water supply should be hard plumbed with a
3/4 in. (1.9 cm) NPT supply and drain. Refer
to Figure 4.1.2 connections.
Is proper air pressure available?
Air pressure required is
CAUTION: Tripping Hazard. If connections are not dropped from the ceiling, all lines and hoses must be covered to prevent trip hazard.
Page | 2004 General Binding Corporation |