Message | Description | |
|
| |
ttttt |
| |
mmm>> | A request for paper of size mmm. | |
PAPER>> | tttttt = TRAY1, FEEDER, TRAY2 (option). | |
REQUEST |
| |
|
| |
| Memory has overflowed for one of the following | |
| reasons. | |
MEMORY | • Too much data on page. | |
• Too much macro data. | ||
OVERFLOW | ||
| • Too much DLL data. | |
| Press RECOVER to continue. Install extra memory or | |
| reduce data on page. | |
|
| |
RECBUF | The receive buffer memory has overflowed. Press | |
RECOVER to continue. The PC ignores printer busy | ||
OVERFLOW | ||
| signal in the interface, check cable pin assignments. | |
Print processing speed could not follow the paper feed | ||
speed. Press RECOVER to continue. Simplify page | ||
OVERRUN | ||
formatting data . | ||
| ||
|
| |
HOST I/F | Indicates an error in the network or RS232C interface. | |
Check protocols of printer and host. Press RECOVER to | ||
ERROR | ||
continue. | ||
| ||
|
| |
TONER | Indicates that TONER LOW has been exceeded and the | |
EMP | cartridge should be replaced. | |
|
| |
tttttt | Wrong paper size found. Open and close printer cover | |
SIZE ERR | to continue. Check paper size or paper double feed. | |
|
| |
tttttt | Paper jam found, when fed from paper tray. Check paper | |
INPUT JAM | in the tray. Open and close printer cover to continue. | |
|
| |
tttttt | Paper jam found, during paper feed. Remove misfed | |
FEED JAM | paper and close printer cover to continue. | |
|
| |
tttttt | Paper jam found in paper exit area. Open printer cover, | |
EXIT JAM | remove paper, close printer cover to continue. | |
|
|
Message | Description | |
|
| |
MENU | Settings Menu. | |
|
| |
COVER | Cover is open. Press down firmly to close. | |
OPEN | ||
| ||
|
| |
EEPROM | EEPROM ID check error. Press RECOVER to reset | |
RESETTING | EEPROM to factory default. | |
|
| |
| Abnormality found in the printer. Switch printer off then | |
ERROR nn | on again to clear, if problem persists, contact service | |
| representative. | |
|
| |
| Abnormality found in the controller. Switch printer off | |
ERROR On | then on again to clear, if problem persists, contact | |
aaaaaaaa | service representative. | |
| aaaaaaaa = error address | |
|
| |
Flash SIMM sum check error. | ||
ERROR |
| |
INITIAL- | Printer is in initialization mode after switching on, prior | |
IZING | to on- line mode. | |
|
| |
RESET TO | Printer is requesting RESET button to be pressed for | |
more than 2 seconds, to write new menu data to | ||
SAVE | ||
EEPROM. | ||
| ||
|
|
22 | OKIPAGE 14ex, 14i, 14i/n |