Oki 14ex, 14i/n manual Hardware problems

Symptom	Problem	Solution
	Much of the printing
	delays will be caused
	by your application.
	Sometimes purely text	For maximum speed,
Printer’s output is	documents will print	use text in your
below rated speed.	slowly depending on	document and use a
	the selected fonts and	printer resident font.
	how they are
	transferred to the
	printer.
		Many software
		packages assume 66
	Creeping text. Number	lines per page, but your
Size of top margin		printer’s default is 64.
	of lines per page in	Adjust software
increases with each	software is not equal to
page printed.	number of lines per	accordingly, or set
		LINES Per PAGE in
	page of printer.
		the soft control panel
		to equal lines per page
		in your software.

Hardware problems

Symptom	Problem	Solution
		Change the resolution,
Graphic image prints	Insufficient printer	reduce the image size,
partly on one page,	memory for this image	or install more
partly on the next.	at this resolution.	memory in your
		printer.

		English
Symptom	Problem	Solution
		Check cable
When you try to print		connection. If more
nothing happens, but	Configuration error.	than one printer is
printer indicates it is		available, make sure
ready to receive data.		your printer has been
		selected.
	Incorrect cable	Check cable
	configuration. Also,
Garbage prints.		configuration,
	see Software
		continuity, and length.
	Problems.
Printer freezes or	Booting the computer
displays error message	while the printer is on	Turn printer off before
when computer is	can cause a	rebooting computer.
rebooted.	communications error.
	Gases are given off by	Make sure the forms
Odours.	forms or adhesives	you use can withstand
	passing through the hot	heating, and provide
	fusing unit.	adequate ventilation.
	Power Save mode is
Printer is on but must	set on to conserve	To eliminate warm up
	energy. The fuser must	delay, change Power
warm up before a job
	heat up before you can	Save setting in Level 2
is printed.
	begin printing the next	Menu.
	job.

User’s Guide 29