Epson TM-U300PD, TM-U300C, TM-U300D, TM-U300PC manual Connecting the Host Computer to the Printer

2-2 Connecting the Host Computer to the Printer

Connect the host ECR (host computer) to the printer using an interface cable that matches the specifications of the printer and the host ECR (host computer).

Be sure to use a drawer that matches the printer’s specifications.

■Connecting the host computer to the TM-U300C/U300D

Connect the interface cable as follows:

➀Turn off the printer and the host ECR (host computer).

➁Plug the serial interface cable connector into the printer’s interface connector: then tighten the screws on both sides of the connector.

➂Plug the drawer kick-out cable connector into the printer’s drawer kick-out con- nector. (You can remove the drawer kick-out cable by pressing in the connector’s clip and pulling out the connector.)

rawer Kick-out Connector

Drawer Kick-out Cable

Interface Connector

Serial Interface Cable

NOTE:

•Your printer comes with inch-type hexagonal lock screws installed. If you plan to use an interface cable that requires millimeter-type lock screws, re- place the inch-type screws with the enclosed millimeter-type screws using a hex screwdriver (5 mm). To distinguish the two types of screws, see the

I	figure below.
	Notch (one or more line)
	Inch-type	Millimeter-type

6