Epson TM-U300C, TM-U300PD, TM-U300D, TM-U300PC Finding the DIP switches, Setting the DIP switches

Page 29

Chapter 4 Setting the DIP Switches

nFinding the DIP switches

As shown in the illustration below, the DIP switches are located on the bottom of the printer. The DIP switches are used to set the printer to perform various func- tions

•The TM-U300C/U300D DIP switches are numbered SW-1 to SW-10 and the TM-U300PC/U300PD DIP switches are numbered SW-1 to SW-8, from left to right as shown in figure below.

•The tables on the following pages describes the DIP switch functions.

■Setting the DIP switches

Follow these steps when changing DIP switch settings:

➀Turn the printer power switch off.

➁Flip the DIP switches using tweezers or another narrow-ended tool. Switches are on when up and off when down in the figure below.

DIP Switches

TM-U300PC/U300PD

piJ@g]

➂The new setting takes effect when you turn on the printer.

NOTES:

• Always change DIP switch settings when the printer is turned off.

• Changes made with the power on have no effect until you turn the printer off and then on again.

23

Image 29

Contents TM-U300C/U300D/U300PC/U300PD TM-U300C/U300D TM-U300PC/U300PD Contents of this manual are subject to change without notice FCC Compliance Statement Introduction Contents Unpacking the Printer Checking the Contents of the Printer BoxRemoving the Transportation Damper Choosing a Place for the PrinterPart names Part Names and Functions➂ Power LED green ➀ Power SwitchFunctions ➁ Feed ButtonConnecting the AC Adapter to the Printer Connecting the CablesConnecting the host computer to the TM-U300C/U300D Connecting the Host Computer to the PrinterConnecting the host computer to the TM-U300PC/U300PD Lnstalling the ribbon cassette Installing the Ribbon CassettePage Replacing the ribbon cassette Installing the paper roll in the TM-U300C/U300PC Installing the Paper RollPage Page Installing the paper roll in the TM-U300D/U300PD Page Page Replacing the roll paper for TM-U300C/U300PC Replacing the paper roll in the TM-U300D/U300PD Paper near-end detector Adjusting the Paper Near-End Detector LocationAdjusting the paper near-end detector Page Inserting a Cut Sheet Validation Paper Validation paper Setting the DIP switches Finding the DIP switchesBaud Rate Selection TM-U300C/U300D DIP Switch FunctionsTM-U300PC/U300PD DIP Switch Functions Running the self test Purpose of the self testHost computer TM-U300C/U300D Self-test Printing SampleRemoving Jammed Paper Removing Jammed PaperCharacter Specifications Appendix A. SpecificationsPrinting Specifications Ribbon Paper Roll Paper Supply DeviceRoll Paper Take-up Device Number of copies 1Ambient temperature Page Environmental Conditions