AMT Datasouth 600 Special Power Up Key Function, Power up key functions, On Line Key Operation

Power up key functions

The table below indicates the function performed when a key is pressed and held while the printer is powered up.

Key	Function
FEED	The printer generates a configuration label. See Printing the
	Configuration Label for details.
PAUSE	The printer performs a Calibration test. See Calibration of
	Media Sensor for details.
CANCEL	Pressing this key bypasses any PALTM program that is loaded
	into the printer and places the printer in its normal mode.
	This is done before loading a new PALTM program into the
	printer. If the CANCEL key is not held down then the
	current loaded application will begin running.

Special Power Up Key Function

Enter into Feature Management Mode

Pressing and holding the FEED key until the READY LED flashes one time will establish a communication between the Fastmark 602 PAL printer and a PC.

This communication is only on the SERIAL port of the printer and FeatureMan must be active on the attached PC. Note: Entering into Feature Management Mode automatically establishes the communication parameters (baud rate, parity, etc) and can not be altered. The Printer is also in an OFF LINE state. Pressing the PAUSE button will cancel Feature Management Mode and place the printer

ON LINE.

Disabling a PALTM program

Pressing and holding the FEED key until the READY LED flashes two times will temporarily disable any loaded PALTM program.

Cycling the printer’s power will re-enable the PALTM program.

ON LINE Key Operation

The table below indicates the functions of a key when pressed after the printer is powered on and in the ready condition.

Key	Function
FEED	No function.
PAUSE	Places the printer Off Line.
CANCEL	No function

Fastmark 600 Series User's Guide 35