AMT Datasouth 600 manual Other User Detected Errors

Other User Detected Errors

The following issues may be detected by the user but may not reported by the printer to the Feature Management Mode.

Description of Issue	Possible Problem	Possible Correcting Procedures
No power or	Printer not attached to a	1.	Verify Power Plug on back of printer is pushed firmly
LEDs are not on	power source.		in.
		2.	Verify Power Adapter is connected to a known power
			source.
		3.	See Maintenance Manual for procedure of verifying
			and changing of the fuse.
	Power Switch is not in the	1.	Verify Switch is in the ‘1’ position.
	on position.	2.	Toggle switch to verify both off and on condition.
	Is the printer in FeatureMan	1.	Press the PAUSE key to see if the Ready LED comes
	mode?		on.
		2.	Cycle Power on the printer.
		3.	Replace the printer.
Media not feeding	Media Latches not closed.	1.	Open the Top Cover.
properly		2.	Verify Media is installed according to the Loading
			Instructions.
		3.	Press firmly on the top of the Printhead Mechanism
			and verify the both the right and left latches are locked.
		4.	Close the Top Cover.
	Media not installed	Verify Media is installed according to the Loading
	correctly	Instructions.
Media is drifting to	Media Guides not in the	1.	Open the Top Cover.
the right as it comes	proper position.	2.	Verify Media is installed according to the Loading
out of the printer.
			Instructions.
		3.	Verify that the right Media is in the proper Position.
			The media needs to be snug between the left and right
			guides.

Fastmark 600 Series User's Guide 73