Description of Issue | Possible Problem | Possible Correcting Procedures | ||
Printer prints a label | Media is not Calibrated | Run Media Calibration procedure | ||
then continually feed |
|
|
| |
Media Sensor not | 3. | Turn off the printer and remove the media. | ||
labels through the | ||||
functioning |
|
| ||
printer. | 4. | Using a Swab dipped in Alcohol clean the Media | ||
| ||||
|
| |||
|
|
| Sensor. See User’s Manual for location of sensor. | |
|
|
| ||
| Spacing between labels is | Verify that the stock matches that of previous roll. If not | ||
| incorrect or does not exist. | contact media supplier. | ||
|
|
| ||
No print on Label | Media Stock incorrect | Is the installed Stock Direct Thermal or Thermal Transfer? | ||
|
| If Thermal Transfer Stock, add the appropriate Ribbon. | ||
|
| To Verify stock is Direct Thermal material, heat the | ||
|
| material. If the material turns color (Black) then stock is | ||
|
| DT. |
| |
|
| If DT media verify that the correct side is next to the print | ||
|
| head. | ||
|
|
|
| |
| Verify printer will do a | 1. | Power on the printer while holding the Feed button. | |
| Self Test |
|
| |
|
|
| ||
| Media installed incorrectly | Verify Media installation using the Loading Instructions. | ||
|
|
|
| |
| No communication with | 1. | Send Data from a host system. | |
| attached host. | 2. | If LED blinks the printed is physically connected by | |
|
| |||
|
|
| the cable. | |
|
| 3. | Reset the Printer to Factory Defaults. | |
|
|
| ||
| Communication | Reset the Printer to Factory Defaults. Then verify host and | ||
| parameters incorrect. | printer communication parameters. | ||
|
|
|
| |
Vertical Streaks on | Dirty printhead | 1. | Turn off power and open the Top Cover and Printhead | |
output |
|
| Mechanism. | |
|
| 2. | Using an alcohol swab wipe the printhead. | |
|
| 3. | Allow the alcohol dry, close the Printhead Mechanism, | |
|
|
| close the Top Cover and retry. | |
|
|
|
| |
| Vertical line on all printed | 1. | Verify line occurs after pressing the Feed Button. | |
| samples. | 2. | Verify nothing in the paper path is causing the line. | |
|
| |||
|
| 3. | If not, replace the Printhead. See Maintenance Manual | |
|
|
| for Procedure. | |
|
| 4. | If replacing Printhead does not correct issue, replace | |
|
|
| PCB. | |
|
|
|
| |
| Media Damage | 1. | Verify there are no nicks or burrs anywhere in the | |
|
|
| paper path such as a scratched rail and that the media is | |
|
|
| not creased. | |
|
|
|
| |
Fastmark 600 Series User's Guide | 75 |