AMT Datasouth 600 manual Appendix E Hidden Setup Features, Hidden Setup Feature and Value List

Appendix E: HIDDEN SETUP FEATURES

To access the hidden list of features, select the Firmware Rev. feature then click the Enter button twice. The hidden feature list is now enabled and may be selected by clicking the Display Down button.

Hidden Setup Feature and Value List

FEATURE NAME	VALUE RANGE	DESCRIPTION
Ripple Pattern	N/A	Click the Enter button to initiate a rolling ASCII ripple
		pattern.
Factory Defaults	N/A	Clicking the Enter button resets all keypad features to
		factory defaults. If the RTC clock is installed, these features
		are not reset. The Label Count Feature can not be reset.
		Caution: This feature could cause a loss of communication
		with host if interface features have been modified.
PAL Boot Drive	[A:,B:,C:, Auto Detect]	This feature selects the boot drive. During power up the
		system will scan the boot drive for a PAL program to run. If
		Auto Detect is selected the system will scan all drives in
		succession, starting with A:, searching for the first PAL
		program to run.
F/W Update Mode	N/A	Clicking the Enter button causes main firmware control to
		be halted and boot load firmware to be loaded. This mode
		has a distinct setup mode feature list allowing serial port
		parameters to be adjusted for the firmware download. See
		Appendix F on firmware updates for more information.
Max Media Length	[12-80] inches (FM602)	This feature sets the maximum length media that the printer
		will recognize. In normal setup mode, this value sets the
	[12-54] inches (FM603)	upper limit on the Media Length feature to avoid excessive
		menu scrolling. This also controls how long of a label the
		printer will look for when performing a label calibration.
		Increase this value if media over 12 inches long is used.
Keypad Lockout	[Enabled, Disabled]	When Keypad Lockout is Enabled, the value of features may
		be viewed but not changed. Also, any feature value which
		TM
		may be changed from downline using a PAL operator is
		also locked out from change. This feature may be used to
		keep users from modifying features or to override host
		changes if needed.
Label Count	N/A	This feature displays the number of labels printed since the
		printer was manufactured. The total label length issued by
		the printer will be dependant on the label length used. For
		example if 4 inch label stock is used and the Label Count
		feature indicates 100, then 400 inches of media have been
		printed.

Fastmark 600 Series User's Guide 86