A&D AD-1191 instruction manual Custom

Page 17

CUSTOM

DOUBLE HIGH

DOUBLE WIDE/HIGH

After you choose one of the magnifications the printer will print Ready to show the printer is out of the configuration menu and the setup menu and is ready to print.

The next setup menu item after CONFIGURE is CUSTOM. With the printer in the setup menu and with CUSTOM as the last item printed, if you press OK (right side) the printer will print the following:

If you press OK the printer will print the current custom setup. A sample is shown below.

This printout shows you how each item is currently set. Below is an explanation of each item and the choices you can make for each.

12

Image 17
Contents Printer for a & D Scales & Balances Page Table of Contents Print Speed Paper Power SpecificationsPage Introduction InstallationPage Page To Remove the Paper Roll Operation MaintenanceChanging the Printer Ribbon Page Printer Test and Setup Configure menu Custom menu SET Clock menu ConfigureBaud Rate Data Bits Load DefaultsFont BUSY-LINE BUSY-BUFFER XON/XOFF-LINE XON/XOFF-BUFFER NoneCustom Page Print Ready Ext Ch SetDOW Pin No CommunicationControl Codes Line Feed Code Example Run Codes 14Number Code Page Character Code Total Page Width MM/DD/YY Custom Menu Default TablePage Warranty and Service Information