A&D AD-1191 instruction manual Load Defaults, Baud Rate Data Bits

Page 15

Load Defaults

The complete list of defaults is shown in the Default Table at the end of this manual.

Baud Rate

Data Bits

With the printer in the setup menu and with CONFIGURE [NEXT/OK] as the last item printed, press OK (right side) to access the CONFIGURE menu. The following is printed:

LOAD DEFAULTS gives you the opportunity to reset the printer to all default settings (shown below).

Choose OK to do this or NEXT to go to the next param- eter. The following is printed:

Baud rate is the next parameter you can set in the CONFIGURE menu. The complete list of parameters and their possible values is shown below.

The sample list above shows the current baud rate is 2400. To accept this, press OK (right side) or view the next baud rate value by pressing NEXT (left side). Press OK when the baud rate you want is displayed

.

Choose from these baud rates;

300, 600, 1200, 2400, 4800, 9600, or 19200

DATA BITS is the next parameter. Choose the data bit value the same way baud rate was chosen. Choices are 7 or 8 data bits.

10

Image 15
Contents Printer for a & D Scales & Balances Page Table of Contents Print Speed Paper Power SpecificationsPage Introduction InstallationPage Page To Remove the Paper Roll Operation MaintenanceChanging the Printer Ribbon Page Printer Test and Setup Configure menu Custom menu SET Clock menu ConfigureBaud Rate Data Bits Load DefaultsFont BUSY-LINE BUSY-BUFFER XON/XOFF-LINE XON/XOFF-BUFFER NoneCustom Page Print Ready Ext Ch SetDOW Pin No CommunicationControl Codes Line Feed Code Codes 14 Number CodeExample Run Page Character Code Total Page Width MM/DD/YY Custom Menu Default TablePage Warranty and Service Information