A&D AD-1191 instruction manual Ext Ch Set, Print Ready

Page 19

Online/Offline

Ext Ch Set

The choice to use the extended character set is available only when 8 data bits are chosen.

Print Ready

SET CLOCK

YES - voltage will be in a low state until the unit is busy then voltage level goes high.

NO - voltage will be in a high state until the unit is busy then voltage level goes low.

ONLINE/OFFLINE is next. Choices:

YES - enables the rocker switch to turn the printer offline.

NO - disables the ONLINE/OFFLINE ability.

EXT CH SET is next. This stands for Extended Character Set. Choices:

YES - Allows you to use hexidecimal numbers above 80 (true only for 8 data bits.)

NO - Disables the Extended Character Set ability.

PRINT READY is next. Choices:

YES - Prints Ready upon power up. NO - Disables printing Ready

WARNING - If you choose NO, then you will need to hold the left side of the rocker switch down for 4 to 6 seconds to access the setup menu. Begin timing when you plug in power to the unit and the red light comes on. The paper feed motor does not run upon power up when Ready is disabled.

The next item in the Setup Menu is SET CLOCK

With the printer in the setup menu and with SET CLOCK as the last item printed, if you press OK (right side) the printer will print the following:

The printout shows the year currently in memory. The 0 is reversed (white on black) to show the position of the cursor. This is the number which will be incremented if NEXT (left side) is pressed. If the number is correct press OK (right side) and the following is printed:

14

Image 19
Contents Printer for a & D Scales & Balances Page Table of Contents Print Speed Paper Power SpecificationsPage Introduction InstallationPage Page To Remove the Paper Roll Operation MaintenanceChanging the Printer Ribbon Page Printer Test and Setup Configure menu Custom menu SET Clock menu ConfigureBaud Rate Data Bits Load DefaultsFont BUSY-LINE BUSY-BUFFER XON/XOFF-LINE XON/XOFF-BUFFER NoneCustom Page Print Ready Ext Ch SetDOW Pin No CommunicationControl Codes Line Feed Code Number Code Codes 14Example Run Page Character Code Total Page Width MM/DD/YY Custom Menu Default TablePage Warranty and Service Information