SIEMENS 5890 DSL Router | Chapter 3 Easy Setup |
User’s Guide | Select Protocol |
|
|
RAW IP
If you selected RAWIP from the Wan Interface page, the RAWIP Networking page is displayed when you click Next.
To configure RAWIP Networking:
1.Select one or more of the following RAWIP Networking options:
•Bridging Enabled:
Forward all traffic for remote hosts that is not routed to the WAN
•IP Routing Enabled:
Routes all IP packets for remote hosts to the WAN. If IP Routing is enabled, you must specify how to obtain an IP address and subnet mask. This can be one of the following:
–Obtain configuration automatically from Wan using DHCP to have an IP address assigned automatically using DHCP.
–Configure IP Routing manually to assign IP addresses manually. If you select this option, you must specify an IP Address and Subnet Mask in the appropriate fields.
2.If you enabled IP routing, optionally select one or more of the following:
•NAT Enabled:
Network Address Translation (NAT) allows multiple workstations on your LAN to share a single, public IP address. All outgoing traffic appears to originate from the router’s IP address.
•Block Net BIOS Traffic:
NetBIOS is a PC networking protocol that can keep network connections open inadvertently. To avoid excess connection charges, such traffic should be blocked on any metered network service.
If your Network Service Provider has not provided specifics for use in making these settings, select Obtain configuration automatically from Wan using DHCP and NAT Enabled.
3.Click Next. This displays the Dynamic Host Configuration Protocol page.
SIEMENS | 26 |