Siemens 5890 manual WAN Selection, Sdsl ATM or Sdsl Frame Relay

SIEMENS 5890 DSL Router	Chapter 5 Advanced Setup
User’s Guide	WAN Selection

WAN Selection

The router can be connected to the internet using IDSL, SDSL, or SHDSL. The connection mode is usually dictated by your service provider. Only one selection is compatible with your ISP’s central office equipment.

To specify the WAN connection mode compatible with your ISP:

1.Click WAN Selection on the left navigation pane of the Router Information page. This displays the WAN Physical Layer Selection page.

2.Select one of the following WAN connection modes:

•IDSL

Be sure to select the switch type from the Switch drop-down menu.

•SDSL ATM or SDSL Frame Relay

Be sure to select the DSLAM from the DSLAM drop-down menu and the Speed from the Speed drop- down menu. This can be one of the following:

-Rate: You must select a speed in the Rate drop-down menu.

-List: The rate is selected from the list based on successful connection. If one rate is unsuccessful, the next rate will be tried, and so on until a rate is successful.

-Auto = Automode if supported. Uses the highest attainable rate allowed by both the line conditions and what is configured in the DSLAM. This is only supported on a few DSLAMs.

•SHDSL

Be sure to select Annex A or Annex B from the Annex drop-down menu. Annex A is typically used in the US and Annex B is typically used in Europe.

3.Click Apply & Reboot. Changing modes results in the deletion of all remotes. You must run Easy Setup again after the reboot completes.

SIEMENS 40