Siemens 5890 manual Siemens

Page 93

SIEMENS 5890 DSL Router

Chapter 6 Security Setup

User’s Guide

IKE/IPSec Configuration

 

 

9.In Destination IP Address, enter the IP address of the remote private network to which your router will connect using this policy.

10.In Destination Subnet Mask, enter the subnet mask of the remote private network to which your router will connect using this policy.

11.In Source Port, enter the port that will be the source of TCP/UDP traffic under this policy. You can specify All ports, a port number, or an IP application associated with a particular port. Because port numbers are TCP and UDP specific, a port filter is effective only when the protocol filter is TCP or UDP.

12.In Destination Port, enter the port that will be the destination of TCP/UDP traffic under this policy. You can specify All ports, a port number, or an IP application associated with a particular port.

13.Click Apply.

SIEMENS

87

Image 93
Contents 5890 Software License Software License and Limited WarrantyGeneral Provisions Table of Contents User Setup Advanced SetupSecurity Setup Monitoring Router Back Panel Front PanelHardware Specifications Software Specifications Frame Relay PPP RFC 1661, RFCSecurity Installation Requirements Package ContentsPC Requirements Network Service Provider Requirements Hardware Installation Windows 98/ME PC ConfigurationSelect TCP/IP Protocol from the Network Protocols list Windows NTWindows Windows XP Mac OS Mac OSX Linux Establish Connection Configuring the RouterTo do this Refer to Router InformationSelect Protocol Access Easy Setup WizardBridging Enabled IP Routing EnabledPoint-to-Point Protocol over ATM VC Multiplexing Block Net Bios Traffic NAT EnabledPoint-to-Point Protocol over ATM LLC Encapsulation NAT Enabled RFC 1483 Multiprotocol Encapsulation LLC/SNAP RFC 1483 VC Multiplexing Routed Point-to-Point Protocol over Ethernet over RFC1483 RFC 1483 MAC Encapsulated Routing MER RAW IP Dynamic Host Configuration Protocol Local Area Network Configuration User Management User SetupAdding/Modifying a User Account Deleting a User Account Local User LookupRadius NoneSecure Mode Configuration TrustedUntrusted Configure the Radius Server Configure the TacPlus Server Class Functional Areas Management ClassesChange Password No access restrictions Access ControlClick Save and Reboot Telnet WebAdvanced Setup Sdsl ATM or Sdsl Frame Relay WAN SelectionRemote File Configuration DMZ DMZ Router Clock Dhcp Dhcp Differentiated Services Framework Weighted Fair QueuingQoS Configure QoS policies Configure QoS Policy Siemens Reorder QoS Policies To the endBefore policy Routing Table Configuration Click Enable Dial Backup Dial BackupATM Traffic Shaping Real-Time Variable Bit Rate Constant Bit RateNon Real-Time Variable Bit Rate Unspecified Bit RateSwitch Management Switch Mirror Configuration Switch Age Time Command Line Interface File Editor Security Setup NAT NAT Server Configuration NAT Host Mapping Disable DefaultPort Number Click Add IP Range Snmp IP FilterEnter the New Password and New Password again Snmp PasswordKey Generator Secure ShellConfigure SSH Load Keys Key Generator Firewall Scripts Firewall Rules Stateful FirewallConfigure Stateful Firewall View Dropped Packets Configure Firewall Rules Application Protocol/PortDelete Firewall Rules IKE/IPSec Configuration Easy IKE/IPSec Setup IKE Peers Advanced IKE/IPSec SetupIKE Peers Definition IKE Proposals Definition IKE IPSec Proposals Definition Siemens IKE IPSec Policies Definition Siemens VPN Log On System Summary Monitoring RouterRemote Connection Information Ethernet Interface InformationSystem Information IP Routing InformationPPPoE Session DiagnosticsATM Statistics Interface InformationFiles Information Routing Table InformationMemory Usage List All Configuration DataTCP/IP Statistics