Siemens TP700 Comfort Programming Software Manual: Configuration and Training Guide

Industry Sector, IA&DT

1.Preface

Regarding its content, module 010-090 is part of the training unit 'Process visualization' and demonstrates how to configure WinCC visualization between the TP700 panel and the SIMATIC S7-300

controller.

More Programming

Languages

Module 40

Basics of PLC

Programming

Module 10, Module 20

Additional Functions for PLC Programming Module 30

PROFIBUS	PROFINET
Module 60	Module 70

Simulation SIMIT

Module 150

AS-Interface

Module 50

Safety/Security

Systems

Module 80

Sensor Technology

Module 110

Process Visualization

(HMI) Module 90

Drives

Module 100

Training objective:

This module describes the most important functions of the WinCC Advanced V11 software.

Typical tasks are performed in a sample plant.

∙"Open" and "Save as" of a STEP 7 project

∙Inserting an HMI station

∙WinCC Advanced V11 interface

∙Configuring display and operating objects

∙Configuring alarms

∙Creating recipe management

∙Setting up user administration

Requirements:

To successfully work through this module, the following knowledge is assumed:

∙Proficiency in working with Windows

∙Basics of PLC programming with the TIA Portal

(e.g. module 020-010 - ‘Startup’ Programming of SIMATIC S7-300 with TIA Portal V11)

∙Blocks for SIMATIC S7-300

(e.g. module 030-010 – Block Types for SIMATIC S7-300 )

∙Timer and counter blocks for SIMATIC S7-300

(e.g. module 030-020 – IEC Timers and IEC Counters for SIMATIC S7-300 )

SCE Training Curriculum	Page 5 of 118	To be used only at Educational and R&D Facilities
TIA Portal Module 090-010, Edition 03/2013		Unrestricted / © Siemens AG 2013. All Rights Reserved

SCE_EN_090-010_R1209_ WinCC Advanced with Runtime and TP700 Comfort Panel