Wacom DTF-720 manual Adjusting the Stand, Installing PL-720 on a Mount Arm

Page 7

Adjusting the Stand

 

1Pull up on the stand adjustment lever.

1

Caution

2

Please hold the stand carefully as

 

you adjust it to prevent injury or damage to the product.

2Lower the stand carefully.

Installing PL-720 on a Mount Arm

This product conforms to the Video Electronics Standard Association’s (VESA) Flat Panel Monitor Physical Mounting Interface Standard (FPMPMI).

This product can be removed from the stand and mounted on such apparatuses as a VESA-standard mount arm. In order to do this, M4/0.7 mm screws, which are not included with the product, are needed. Use screws that will, at the time of installation, penetrate the surface of the product by no more than 15 mm. Use of longer screws may result in damage to internal parts of the

product.

1Make sure that both your computer and the product are turned off and that all cables are disconnected.

2Place the display unit face down on a flat surface. To prevent harm to the front of the unit, fi rst spread a cloth or similar material on the fl at surface as a cushion.

3Remove the four screws that hold the stand to the unit.

4Using four M4/0.7mm screws, securely mount the arm or similar apparatus to the back of the unit.

5Connect the cables and save the screws that you removed in step 3.

Caution

When installing the unit on a mount arm or other stand, always follow the directions in the instruction booklet for the mount arm or stand, as well as the instructions contained in this document. Incorrect installation may result in the product coming loose and falling, possibly causing product failure.

6

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 7
Contents PL-720 PL-720 Users Guide Table of ContentsRegarding the power plug and power adapter Safety PrecautionsDo not open the back cover Do not let the product get wet Do not use organic solvents to clean this productWhen connecting the power plug When not using this product for a long period of timePlease be aware of the following regarding the LCD display Warranty ExclusionsFront Component FunctionsBack Installing PL-720 on a Mount Arm Adjusting the StandAccessory Check Connecting PL-720 Computer Windows Setup Installing PL-720 DriverInstalling the Tablet Driver Macintosh Mac OS X SetupUninstalling the Tablet Driver WindowsPL-720 Power Saving Function Auto-Adjust FunctionPL-720 Display Blurring and Protrusion of the Picture from the LCD Panel ProcedureOn-Screen Display OSD Menu Buttons How to Use the OSD MenuBrightness Backlight ResetTypes of OSD Menus Contrast LanguageVertical Center Pitch Horizontal Center PhaseName Function How to use the Tablet ButtonsBasic operation Component FunctionsOpening the Control Panel in Windows Using the Control PanelDisplaying the Control Panel Control Panel BasicsFunction Names Description Switch and Button SettingsOpen/Run Customizing the Pop-up MenuSynchronizing the Positions of the Pen Tip and Pointer If Another Monitor Name is Displayed in the Monitor Field Using Multiple Interactive Pen Displays【Important】 Remove the pen nib Insert a new nib Supplementary InformationRemoving Stains Replacing the Pen NibIf One of These Conditions Should Appear TroubleshootingDisplay Troubleshooting If One of These Messages Should AppearTroubleshooting for Windows General TroubleshootingCondition Specification Troubleshooting for MacintoshObtaining Technical Support