Toshiba B-SA4TM SERIES, EO1-33047 owner manual Installation

2. PRINTER SETUP

ENGLISH VERSION EO1-33047

2.2 Connecting the Power Cord

2.1 Installation

2.1.1Attaching the Printer Rear Support

NOTE:

The Printer Rear Support can be attached in either way of A or B. But A is more stable than B.

AB

2.2Connecting the Power Cord

CAUTION!

As a Power Cord is not supplied with the printer, please purchase an approved on that meets the safety standard of each country. (Refer to APPENDIX 3.)

To insure the best operating environment, and to assure the safety of the operator and the equipment, please observe the following precautions.

•Operate the printer on a stable, level, operating surface in a location free from excessive humidity, high temperature, dust, vibration or direct sunlight.

•Keep your work environment static free. Static discharge can cause damage to delicate internal components.

•Make sure that the printer is connected to a clean source of AC Power and that no other high voltage devices that may cause line noise interference are connected to the same mains.

•Assure that the printer is connected to the AC mains with a three- prong power cable that has the proper ground (earth) connection.

Attach the supplied Printer Rear Support to the bottom of the printer back with the SMW-4x8 screw, as shown in the picture below.

SMW-4x8

Printer Rear Support

1.Make sure that the printer Power Switch is in the OFF ({) position. Connect the Power Cord to the printer as shown in the figure below

Power Switch Power Cord

2.Plug the other end of the Power Cord into a grounded outlet as shown in the figure below.

Power Cord Power Cord

[Example of US Type] [Example of EU Type]

E2- 2