Toshiba B-SA4TM SERIES, EO1-33047 owner manual Appendix 2 Interface

APPENDIX 2 INTERFACE

ENGLISH VERSION EO1-33047

APPENDIX 2 INTERFACE

APPENDIX 2 INTERFACE

NOTE:

To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:

•In case of a parallel interface cable or serial interface cable, fully shielded and fitted with metal or metallised connector housings.

•Keep as short as possible.

•Should not be bundled tightly with power cords.

•Should not be tied to power line conduits.

•A parallel interface cable to be used should conform to IEEE1284.

Parallel interface (Centronics)

Mode:	Conforming to IEEE1284
	Compatible mode (SPP mode), Nibble mode
Data input method: 8 bit parallel
Control signal:
	SPP Mode	Nibble Mode
	nStrobe	HostClk
	nAck	PtrClk
	Busy	PtrBusy
	Perror	AckDataReq
	Select	Xflag
	nAutoFd	HostBusy
	nInit	nInit
	nFault	nDataAvail
	nSelectIn	IEEE1284Active
Data input code:	ASCII code
	European 8 bit code
	Graphic 8 bit code
	JIS8 code
	Shift JIS Kanji code
	JIS Kanji code
Receive buffer:	1M byte

EA2- 1